Results 181 to 190 of about 730,971 (212)
Some of the next articles are maybe not open access.
2003
In Chapter 8, operation planning was analyzed. It was shown that selecting an operation plan is not an independent decision; it depends on the selected depth of cut. However, the decision of selecting a depth of cut was partially based on the feed rate decision.
openaire +1 more source
In Chapter 8, operation planning was analyzed. It was shown that selecting an operation plan is not an independent decision; it depends on the selected depth of cut. However, the decision of selecting a depth of cut was partially based on the feed rate decision.
openaire +1 more source
International Journal of Machine Tools and Manufacture, 2021
Bing Wang, Zhanqiang Liu, Yukui Cai
exaly
Bing Wang, Zhanqiang Liu, Yukui Cai
exaly
Optimization of the cutting speed at milling
2001Milling process is influenced by a lot of parameters. Main parameters are workpiece material, cutting tool material, cutting geometry and cutting conditions. Cutting tool geometry has very important role in cutting process, specially wedge angle .
Cebalo, Roko, Stoić, Antun
openaire +1 more source
Chip morphology and cutting temperature of ADC12 aluminum alloy during high‐speed milling
Rare Metals, 2020Xinxin Meng, You-Xi Lin
exaly
Synthetic Consideration on the Cutting Force and Cutting Speed by the Metal Cutting
Journal of the Society of Mechanical Engineers, 1946Keikiti EBIHARA, Masami MASUKO
openaire +1 more source