Modelling and simulation of the dynamic cutting process and surface topography generation in nano/micro cutting [PDF]
, 2008 In nano/micro cutting process, the surface quality is heavily dependent on all the dynamic factors in machining including those from the material, tooling, cutting parameters, servo accuracy, mechanical structure deformation, and non-linear factors as ...
Cheng, K, Zhou, L
core +6 more sources
An investigation on micro cutting mechanics: Modelling, simulations and experimental case studies [PDF]
, 2014 This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University London.Micro cutting is becoming increasingly important since miniature and micro components/products have become more and more demanded in precision ...
Sawangsri, Worapong
core +7 more sources
Improvement of Cutting Forces Modeling Based on Oriented Cutting Tests [PDF]
, 2013 In order to predict the characteristics of the machined part, such as geometry, surface roughness and fatigue or corrosion resistance, the cutting forces values should be known as precisely as possible.
Gérard Poulachon +10 more
core +1 more source
Modelling flan wear of carbide tool insert in metal cutting [PDF]
, 2005 In this paper theoretical and experimental studies are carried out to investigate the intrinsic relationship between tool flank wear and operational conditions in metal cutting processes using carbide cutting inserts.Anewflank wear rate model, which ...
Liu, X +7 more
core +1 more source
An Innovative Experimental Study of Corner Radius Effect on Cutting Forces [PDF]
, 2014 The cutting forces are often modelled using edge discretisation methodology. In finish turning, due to the smaller corner radii, the use of a local cutting force model identified from orthogonal cutting tests poses a significant challenge. In this paper,
BISSEY BRETON, Stéphanie +4 more
core +1 more source
Design and analysis of a piezoelectric film embedded smart cutting tool [PDF]
, 2013 This is the author's accepted manuscript. The final published article is available from the link below. Copyright @ 2012 Institution of Mechanical Engineers.The condition of a cutting tool is an important factor for manufacturing processes.
Cheng, K, Rakowski, R
core +1 more source
Simulation of the deflected cutting tool trajectory in complex surface milling [PDF]
, 2011 Since industry is rapidly developing, either locally or globally, manufacturers witness harder challenges due to the growing competitivity. This urges them to better consider the four factors linked to production and output: quality, quantity, cost and
Baili, Maher +9 more
core +1 more source
Comparison of Machining Characteristics of PCD Gun Drill and PCD Twist Drill Manufactured by Brazing [PDF]
한국정밀공학회지Recently, lightweight materials centered on the future mobility industry are used in various parts such as battery housings and EV platform frames to improve fuel efficiency of automobile engines.
Ho Min Son +3 more
doaj +1 more source
Development of Brazing Device and Fabrication of Its PCD Tip Brazed Cutting Tools [PDF]
한국정밀공학회지In recent years, the demand for lightweight parts has been gradually increasing, particularly in the E-mobility industry. Among lightweight materials, aluminum alloys are highly beneficial for improving the fuel efficiency of automobile engines due to ...
Min-Woo Sa +3 more
doaj +1 more source
Cutting Forces Modeling in Finish Turning of Inconel 718 Alloy with Round Inserts [PDF]
, 2011 In turning, the applied forces have to be known as accurately as possible, especially in the case of difficult-to-cut materials for aircraft workpieces finishing operations.
Gérard Poulachon +7 more
core +1 more source