Results 231 to 240 of about 534,622 (309)
The Study of Low-Cycle Fatigue Properties and Microstructure Along the Thickness Direction of a 460 MPa Marine Engineering Steel. [PDF]
Xue C, Yang M, Ren X, Wang L, Zhou X.
europepmc +1 more source
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Effect of Shot Peening Pretreatment on the Fatigue Behavior of AA5052/SPFC440 Self-Piercing Riveted Joints. [PDF]
Zhou Z, Ji X, Huang Z, Gu X, Zhang Y.
europepmc +1 more source
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Failure Behavior and Mechanism of Solder Joint Under Thermal Mechanical Coupling Loads. [PDF]
Deng Y +6 more
europepmc +1 more source
Immunomodulatory Properties of the Cyclic Lipopeptide Surfactin. [PDF]
Madhi I, Kim Y.
europepmc +1 more source
Static and Cyclic Mechanical Behavior of 3D-Printed PEEK Under Tensile and Compressive Loads. [PDF]
Pina F +3 more
europepmc +1 more source
Cyclic Olefin Copolymer with a Noble Metal Nanostructures as an Antibacterial Material. [PDF]
Slepička P +9 more
europepmc +1 more source

