Results 231 to 240 of about 181,167 (285)

A Cyclic Resistance Ratio Model of Sand-Fines Mixtures Based on Cyclic Triaxial Test

Geotechnical and Geological Engineering, 2023
Ke Cheng, Yang Zhang
semanticscholar   +1 more source

Elasto-plastic characteristics of the clay soil mixed with rubber waste using cyclic triaxial test results

Arabian Journal of Geosciences, 2022
Davood Akbarimehr, S. Hosseini
semanticscholar   +1 more source

Experimental study on unconfined compressive and cyclic triaxial test behavior of agar biopolymer–treated silty sand

Arabian Journal of Geosciences, 2021
S. Smitha, K. Rangaswamy
semanticscholar   +1 more source

Results of the cyclic triaxial testing on mechanically–biologically treated waste

Waste Management & Research: The Journal for a Sustainable Circular Economy
Accurate assessment of the dynamic strength characteristics of mechanically–biologically treated (MBT) waste is crucial for the construction and safe operation of landfill sites. Herein, samples of MBT waste from the Hangzhou Tianziling landfill were collected and subjected to consolidated undrained cyclic triaxial tests under four confinement levels ...
Tuo Li, Zhenying Zhang, Youwen Zhang, Wenjie Chen   +3 more
openaire   +2 more sources

Experimental and numerical study on rockburst triggered by tangential weak cyclic dynamic disturbance under true triaxial conditions

Tunnelling and Underground Space Technology, 2018
The excavation and/or dynamic disturbance induced critically stressed (stress close to the strength of the rocks) rocks near the excavation boundary of deep openings are highly unstable, and they may fail violently in the form of rockburst triggered by ...
L. Hu, Ke Ma, Xin Liang, Chun’an Tang, Zhenwei Wang, Liubin Yan   +5 more
semanticscholar   +1 more source

Regression Models for Validating Cyclic Triaxial Test Results

Geotechnical Testing Journal, 2011
Abstract Cyclic triaxial tests are commonly used to evaluate a soil’s potential for liquefaction during seismic events. Following testing, it is necessary to evaluate the validity of the test results. This can be a difficult task unless the engineer has previously acquired a reasonable amount of experience with this type of testing.
openaire   +1 more source

Cyclic Triaxial Strain-Controlled Testing of Liquefiable Sands

1988
Two series of undrained cyclic triaxial strain-controlled tests were performed on two different Imperial Valley, California, silty sands which liquefied during an earthquake in 1981. Both intact and reconstituted specimens were tested, and the testing procedures are described.
M Vucetic, R Dobry
openaire   +1 more source

Mechanical performance of recycled aggregates in cyclic triaxial testing

2017
In Belgium, more than 6,000 t of recycled concrete and masonry aggregates are produced every year, coming from civil engineering demolition works. They contain up to 50% of masonry. It is allowed to recycle them in road bases and subbases if they satisfy the requirements set in the standard specifications.
C. Grégoire, A. Van der Wielen, B. Janssens   +2 more
openaire   +1 more source

A Review of Factors Affecting Cyclic Triaxial Tests

1978
The effects of testing procedures and material characteristics on the cyclic triaxial strength of cohesionless soils were reviewed with the intent of categorizing the significance of these factors for cognizance in future testing standards. It was found that specimen preparation methods, differences between intact and reconstituted specimens, density ...
openaire   +1 more source

Influence of Fines Contents on Soil Liquefaction Resistance in Cyclic Triaxial Test

Geotechnical and Geological Engineering, 2020
Jungang Liu
semanticscholar   +1 more source