Investigating the effect of rotational degree of freedom on a circular cylinder at low reynolds number in cross flow [PDF]
, 2011 Numerical simulations of Vortex-Induced Vibrations (VIV) of a circular cylinder in cross flow with a rotational degree of freedom about its axis have been carried out by means of a finite-volume method.
Wissink, J +5 more
core +6 more sources
Semi-Automated Segmentation of Geometric Shapes from Point Clouds
Remote Sensing, 2022 Building information models (BIM) in the civil industry are very popular nowadays. The basic information of these models is the 3D geometric model of a building structure.
Richard Honti +2 more
doaj +1 more source
Passive control of wake flow behind a square cylinder using a flat plate
Frontiers in Physics, 2023 In this study, control over the wake flow of a single square cylinder exercised by a flat plate attached to the rear side of the cylinder is analyzed numerically via the lattice Boltzmann method.
Waqas Sarwar Abbasi +6 more
doaj +1 more source
Three-dimensional coating and rimming flow : a ring of fluid on a rotating horizontal cylinder [PDF]
, 2013 The steady three-dimensional flow of a thin, slowly varying ring of Newtonian fluid on either the outside or the inside of a uniformly rotating large horizontal cylinder is investigated.
Wilson, Stephen +2 more
core +4 more sources
Large eddy simulation of flow past a stationary and controlled oscillating circular cylinder at RE=5500 [PDF]
, 2013 Vortex shedding from a stationary cylinder and transversely oscillating circular cylinder in a uniform flow at a Reynolds number of 5500 is numerically studied by three-dimensional Large Eddy Simulation (LES). The filtered equations are discretised using
Kim, Sunghan +2 more
core +2 more sources
The influence of coolant scale deposit inside the internal combustion engine on the piston and cylinder deformations [PDF]
Transport, 2005 This paper presents the analysis of the influence of engine coolant scale deposits on the deformations in the piston – cylinder pair. The results of carried out calculations enable to make more precise evaluation of cylinder repair dimensions. The aim of
G. Garbinčius +3 more
doaj +3 more sources
The Force Exerted by Surface Wave on Cylinder and Its Parameterization: Morison Equation Revisited
Journal of Marine Science and Engineering, 2022 The Morison equation is widely used to estimate the loads by surface waves on cylinders. The formulation and coefficients determination method of the original work by Morison et al.
Xiaoxiao Zan, Zhenhua Lin, Ying Gou
doaj +1 more source
Modelling one-dimensional elastic diffusion processes in an orthotropic solid cylinder under unsteady volumetric perturbations [PDF]
Vestnik Samarskogo Gosudarstvennogo Tehničeskogo Universiteta. Seriâ: Fiziko-Matematičeskie Nauki, 2022 A polar-symmetric elastic diffusion problem is considered for an orthotropic multicomponent homogeneous cylinder under uniformly distributed radial unsteady volumetric perturbations.
Andrei V Zemskov +2 more
doaj +1 more source
High-order methods for steady, unsteady and transitional flow over a cylinder [PDF]
, 2012 In this thesis, the flow around a cylinder is chosen as a test case for higher-order numerical reconstruction techniques. No direct comparison of these higher-order methods has been carried out for this particular test case.
Starr, Maxwell
core +7 more sources
Energies, 2020 Since pneumatic systems are widely used in various branches of industry, the need to find ways to reduce energy consumption in these systems has become very pressing.
Vladislav Blagojevic +3 more
doaj +1 more source