Results 251 to 260 of about 3,565,443 (297)
Some of the next articles are maybe not open access.
Optimal damping ratio of TLCDs
Structural Engineering and Mechanics, 2000The study of the optimal damping ratio of a tuned liquid-column damper (or TLCD) attached to a single-degree-of-freedom system is presented. The tuned liquid-column damper is composed of two vertical columns connected by a horizontal section in the bottom and partially filled with water.
Chen, Yung-Hsiang, Chao, Chen-Chi
openaire +1 more source
Journal of the Geotechnical Engineering Division, 1977
Using the Torsional Simple Shear Device, the writers investigated the relationship between damping ratio λ\N and shear strain γ\N for Ottawa, Del Monte, Golden Gardens, and Seward Park sands. Experimental results show that the type of sand, as expressed in soil gradation and angularity, influences soil damping. However, this influence can be taken into
Mehmet A. Sherif +2 more
openaire +1 more source
Using the Torsional Simple Shear Device, the writers investigated the relationship between damping ratio λ\N and shear strain γ\N for Ottawa, Del Monte, Golden Gardens, and Seward Park sands. Experimental results show that the type of sand, as expressed in soil gradation and angularity, influences soil damping. However, this influence can be taken into
Mehmet A. Sherif +2 more
openaire +1 more source
Shear modulus and damping ratio of grouted sand
Soil Dynamics and Earthquake Engineering, 2004An experimental comparative study of three different grouted sands in terms of their effects on the values of two dynamic properties is presented. The dynamic properties studied are the shear modulus and the damping ratio which are determined with resonant column tests and cyclic triaxial tests.
Delfosse-Ribay, Estelle +3 more
openaire +2 more sources
On the damping ratio of multi‐degree‐of‐freedom systems
Communications in Applied Numerical Methods, 1992AbstractThe damping parameter is commonly used when assessing a vibration system or analysing dynamical response, as well as reducing vibration levels. A basic step towards analysing a damped system is to solve its complex eigenvalues. However, the solution is computer‐time‐consuming.
Man, Liu, Wilson, J. M.
openaire +1 more source
Study of Damped Critical Speeds and Damping Ratios of Flexible Rotors
Journal of Vibration and Acoustics, 1984Influences of bearing damping on critical speeds of flexible rotors are investigated. First, the damped critical speed and the damping ratio of a uniform shaft supported at both ends are examined. It is shown that there exists an optimum bearing damping that gives the maximum damping ratio for each order of critical speed, and that with increasing ...
Shinobu Saito, Tsuneo Someya
openaire +1 more source
Evaluation of Absolute Damping from Modal Damping Ratios
2004In the previous chapters, we determined the natural frequencies and modal shapes for undamped structures when modeled as shear buildings. We also determined the response of these structures using the modal superposition method. In this method, as we have seen, the differential equations of motion are uncoupled by means of a transformation of ...
Mario Paz, William Leigh
openaire +1 more source
Damping mechanisms and damping ratios in vibrating unreinforced stone masonry
Engineering Structures, 2010Abstract In seeking to understand the dynamic behaviour of historic stone structures, eight representative walls were constructed and tested under in-plane free vibration conditions. Each wall consisted of two wythes, one sandstone, one limestone, joined by a rubble core of small stones and mortar.
Abdelsamie Elmenshawi +4 more
openaire +1 more source
On Damping Ratio Estimation in Electronic Semi-active Suspensions
2021 American Control Conference (ACC), 2021In semi-active suspensions, the damping force is not regulated by acting directly on the damping ratio itself, but rather on a related variable, usually a current. Unfortunately, the same current may produce different damping ratios, depending on the status of the shock absorber.
Savaresi D. +4 more
openaire +3 more sources
Effects of Time on Damping Ratio of Clays
1978Laboratory tests with a Hardin oscillator were used to study the time-dependent characteristics of the damping ratio of isotropically consolidated specimens of kaolinite and calcium bentonite. Damping was determined using a steady-state method and from the decay of free vibrations.
WF Marcuson, HE Wahls
openaire +1 more source
Damping ratio of polynomials with perturbed coefficients
IEEE Transactions on Automatic Control, 1988Let a family of polynomials be (1) \(P(s)=t_ 0s^ n+t_ 1s^{n- 1}+...+t_ n\) where ...
Soh, C. B., Berger, C. S.
openaire +2 more sources

