Results 31 to 40 of about 506,427 (304)
Adjustable inertial response from the converter with adaptive droop control in DC grids [PDF]
In a DC grid, the inherent inertial support from the DC capacitors is too small to resist step changes or random fluctuations from the intermittent power resources, which results in lower DC voltage quality. In this paper, an adaptive droop control (ADC)
Hei, Yang +4 more
core +1 more source
A Novel Grid Connected Dc-Dc Converter
This paper proposes a three-port grid based dc-to-dc power conversion circuit for low range distributed systems. With this converter, the load can be powered from two different dc sources, which can be a combination of two from a solar-cell panel, a fuel-cell set, a battery bank, etc. and grid source,.
G K Mahesh,, R.Lokeswar Reddy
openaire +1 more source
Passivity-based harmonic control through series/parallel damping of an H-bridge rectifier [PDF]
Nowadays the H-bridge is one of the preferred solutions to connect DC loads or distributed sources to the single-phase grid. The control aims are: sinusoidal grid current with unity power factor and optimal DC voltage regulation capability.
De Vries, M. M. J., +4 more
core +4 more sources
The operation of an Ultra-High Voltage (UHV) shunt reactor generates significant acoustic signals containing crucial information. To accurately assess the various acoustic parameters of ultra-high voltage shunt reactors, it is crucial to establish an ...
Yingwen Li +5 more
doaj +1 more source
A New Buck-Boost AC/DC Converter with Two-Terminal Output Voltage for DC Nano-Grid
Due to the development and deployment of renewable DC power sources and their inherent advantages for DC loads in applications, the DC nano-grid has attracted more and more research attentions; especially the topologies of AC/DC converters are ...
Xiangkun Li +5 more
doaj +1 more source
Bipolar output direct‐coupled DC–DC converter applied to DC grids
The unipolar‐input bipolar‐output DC–DC converters with megawatt rating are the key equipment in the multi‐terminal HVDC and DC grids, especially in the DC wind farm. This paper presents a novel direct‐coupled transformerless DC–DC converter to interconnect unipolar DC system with bipolar DC transmission line based on cascaded sub‐modules.
Lingyu Guo +3 more
openaire +2 more sources
Power quality issues of 3MW direct-driven PMSG wind turbine [PDF]
This paper presents power quality issues of a grid connected wind generation system with a MW-class direct-driven permanent magnet synchronous generator (PMSG).
Ahmed, IA, Taylor, GA, Zobaa, AF
core +1 more source
Smart grids are incessantly contemplating new challenges about power electronics technologies, and this paper focuses on the application of solid-state transformers (SSTs) and the forthcoming perspective of hybrid AC/DC grids. In such perspective, a multilevel bidirectional four-port (MB4P) DC-DC converter is proposed to be integrated in a three-phase ...
Monteiro, Vítor Duarte Fernandes +2 more
openaire +2 more sources
A Terminal Tube Text Detection and Recognition Method Based on Improved YOLOv7-Tiny and CRNN
In the process of intelligent inspection of substation terminal line, the automatic identification of terminal coding tube is a crucial step. This study proposes a new method for text detection and recognition of terminal coding tube based on deep ...
Liao Huilian +5 more
doaj +1 more source
Comparative study of conventional sliding mode control and integral sliding mode control for a bidirectional dc-dc converter in an electric vehicle charger [PDF]
Bidirectional dc-dc converters are crucial for integrating electric vehicles (EVs) with the electrical grid, facilitating both grid-to-vehicle (G2V) and vehicle to grid (V2G) energy transfers.
Oualifi Khadija +5 more
doaj +1 more source

