Results 71 to 80 of about 3,183 (266)

Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites

Advanced Engineering Materials, EarlyView.
Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter, Andreas Bezold, Johan Westraadt, Katharina Fiegl, Subham Chattoraj, Benjamin Wahlmann, Carolin Körner, Michael Mills, Mathias Göken, Steffen Neumeier   +9 more
wiley   +1 more source

An asymmetrical quadruple active bridge series resonant DC–DC converter for modular solid‐state transformers

IET Power Electronics
The DC–DC conversion stage of a three‐stage solid‐state transformer is the most challenging due to the combination of high power, medium voltage, and medium frequency. This combination also causes most of the losses in the DC–DC stage.
Saeid Khani, Seyed Hossein Hosseini, Mehran Sabahi   +2 more
doaj   +1 more source

Current Status and Challenges in Data Collection for Aerospace Coatings Deposited by Plasma Spraying

Advanced Engineering Materials, EarlyView.
An innovative approach has been integrated into the GRENAT project to optimize plasma spraying and coating performance. Raw materials are accelerated and melted in the plasma generated by torches, creating coatings. Monitoring sensors collect process data which are combined with ex situ characterization data.
Lila Randriamananjara, Vincent Rat, Quentin Dubreuil, Patrice Valorge, Simon Goutier, Alain Denoirjean, Olivier Messe, Céline Ruelle, Jean‐Philippe Poli   +8 more
wiley   +1 more source

A Practical Noise2Noise Denoising Pipeline for High‐Throughput Raman Spectroscopy

Advanced Engineering Materials, EarlyView.
A lightweight and reproducible denoising pipeline for high‐throughput Raman spectroscopy is introduced, based on a 1D convolutional autoencoder trained with a Noise2Noise strategy. Using only repeated short‐exposure acquisitions, the method suppresses stochastic noise without reference spectra, enabling reliable spectral reconstruction while preserving
David Martin‐Calle, Cesar Alvarez‐Llamas, Vincent Motto‐Ros, Christophe Dujardin, Jérémie Margueritat, David Rodney   +5 more
wiley   +1 more source

Combination Optimization Configuration Method of Capacitance and Resistance Devices for Suppressing DC Bias in Transformers

Energies, 2019
The ground current of a high-voltage direct current (HVDC) transmission system can cause DC bias in transformers near the grounding electrode during monopole operations, which affects the alternating current (AC) power system operation. Owing to multiple
Donghui Wang, Chunming Liu
doaj   +1 more source

Uniform Amorphization of Crystalline Silicon Surfaces Enabled by Deep Ultraviolet Femtosecond Laser Pulses

Advanced Engineering Materials, EarlyView.
Deep‐UV (258 nm) femtosecond pulses enable uniform amorphous silicon writing on Si(100)/(111) with a six‐fold larger fluence amorphization window than NIR methods. Optimized fluence and overlap yield 20–45 nm uniform and continuous amorphous layers. Microscopy shows sharp interfaces, and real‐time reflectivity reveals nanosecond melt–resolidification ...
Wissal Benali, Magali Gregoire, Matys Guyard, Tatiana Itina, David Grojo, Pol Sopeña   +5 more
wiley   +1 more source

A New Hard Switching Bidirectional Converter With High Power Density [PDF]

Journal of Intelligent Procedures in Electrical Technology, 2010
In this paper, a new isolated dc-dc bidirectional converter is proposed. This converter consists of two transformers (flyback and forward) and only one switch in primary side and one switch in secondary side of transformers.
Bahador Fani, Majid Delshad, Daryoosh Nazarpour   +2 more
doaj  

Control of Polarization and Polar Helicity in BiFeO3 by Epitaxial Strain and Interfacial Chemistry

Advanced Functional Materials, EarlyView.
In BiFeO3 thin films, the interplay of interfacial chemistry, electrostatics, and epitaxial strain is engineered to stabilize homohelicity in polarization textures at the domain scale. The synergistic use of a Bi2O2‐terminated Aurivillius buffer layer and a highly anisotropic compressive epitaxial strain offers new routes to control the polar‐texture ...
Elzbieta Gradauskaite, Lilia Huynh, Natascha Gray, Quintin N. Meier, Marta D. Rossell, Morgan Trassin   +5 more
wiley   +1 more source

Intermediate Resistive State in Wafer‐Scale Vertical MoS2 Memristors Through Lateral Silver Filament Growth for Artificial Synapse Applications

Advanced Functional Materials, EarlyView.
In MOCVD MoS2 memristors, a current compliance‐regulated Ag filament mechanism is revealed. The filament ruptures spontaneously during volatile switching, while subsequent growth proceeds vertically through the MoS2 layers and then laterally along the van der Waals gaps during nonvolatile switching.
Yuan Fa, Milan Buttberg, Ke Ran, Rana Walied Ahmad, Dennis Braun, Lukas Völkel, Jimin Lee, Sofía Cruces, Bart Macco, Bárbara Canto, Holger Lerch, Thorsten Wahlbrink, Holger Kalisch, Michael Heuken, Andrei Vescan, Joachim Mayer, Zhenxing Wang, Ilia Valov, Stephan Menzel, Max C. Lemme   +19 more
wiley   +1 more source

Development of an Electromagnetic‐Thermal Circuit Model for Single‐Phase Three‐Limb Transformers

High Voltage
Analysing the heat states of transformers under DC bias requires careful consideration of their own structural and material characteristics. Although the 3D finite element method (FEM) is a reliable way of simulating all the details of transformers, it ...
Yidan Hu, Jiawen Yu, Zhaoyu Zhang, Xuanrui Zhang, Junhao Li, Roberto Ottoboni   +5 more
doaj   +1 more source