Results 141 to 150 of about 384,659 (316)
Advanced Engineering Materials, EarlyView.Geometry‐driven thermal behavior in wire‐arc additive manufacturing (WAAM) influences microstructural evolution during nonequilibrium solidification of a chemically complex Fe–Cr–Nb–W–Mo–C nanocomposite system. By comparing different deposits configurations, distinct entropy–cooling rate correlations, segregation, and carbide evolution are revealed ...
Blanca Palacios +5 more
wiley +1 more source
Independent Component Analysis as a Tool for Ground Deformation Analysis
, 2007 Independent component analysis (ICA) is a recent and well-known technique used to separate mixtures of signals. This technique has been applied to the ground deformation time-series recorded at the permanent GPS network of the Osservatorio Vesuviano ...
U. TAMMARO +13 more
core +1 more source
Advanced Engineering Materials, EarlyView.Thermomechanical fatigue tests of laser beam powder bed fusion (PBF‐LB) Inconel 718 show that the additively manufactured material reaches almost the lifetimes of conventionally‐rolled material under no‐dwell conditions. Introducing dwell times at the maximum temperature markedly reduces the lifetimes due to pronounced grain boundary sliding associated
Stefan Guth +6 more
wiley +1 more source
Comparison of deformation analyses performed on the basis of GNSS observations using single-frequenc y and double-freque ncy measurement receivers [PDF]
Acta Montanistica Slovaca, 2012 The given article addresses 2D processing of a deformation network measured using Global Navigation Satellite Systems in partof the Dargovských Hrdinov housing estate.
Pavel Kukučka +3 more
doaj
Large deformation analysis of a backside-supported snap-fit with nonlinear behavior. [PDF]
Heliyon, 2023 El Otmani S, Shin DK.
europepmc +1 more source
, 2017 Relating macroscopic deformation of granular media to grain-scale processes, such as grain fracturing, has been a focus of many studies. Understanding these processes is key for predicting surface subsidence and induced seismicity caused by hydrocarbon ...
Cordonnier, Benoit +4 more
core
, 2010 The large deformation analysis is one of major challenges in numerical modelling and simulation of metal forming. Because no mesh is used, the meshfree methods show good potential for the large deformation analysis.
Gu, YuanTong
core +1 more source
Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition
Advanced Engineering Materials, EarlyView.A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley +1 more source
Studies on the Development of Fabrics in Some Naturally Deformed Limestones [PDF]
, 1962 The purpose of this investigation has been to study in detail the development of deformation fabrics in some naturally deformed limestones, with a view of testing the geological applicability of experimentally deduced origins of such fabrics in these ...
Conel, James Ekstedt
core
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source