Results 21 to 30 of about 4,202 (219)
Acrylic denture base repair (Part II): St-rength of acrylic denture base cured by four different techniques [PDF]
Al-Rafidain Dental Journal, 2006 Aim: To investigate the effect of repair techniques, surface treatment, and repair space design (3 mm space and no repair space) on the transverse, and tensile strengths of repaired denture base. Materials and methods: Four hundred and sixteen samples of
Repair acrylic denture base, microwave, thermo press. +1 more
doaj +1 more source
International Journal of Dentistry, 2016 Background. Type of materials used in fabrication of denture base has an effect on dimension during denture base material processing and other factors related to clinical use. Objective.
Khalid A. O. Arafa
doaj +1 more source
The Journal of Indian Prosthodontic Society, 2015 Statement of Problem: The occurrence porosity in polymethyl methacrylate, the most commonly used denture base material is a problem. The occurrence of oral candidiasis and other infections has also been reported in denture users.
U K Kartika +4 more
doaj +1 more source
Contemporary Clinical Dentistry, 2012 Background and Aim: This study was formulated to evaluate and estimate the influence of various denture base resin surface pre-treatments (chemical and mechanical and combinations) upon tensile bond strength between a poly vinyl acetate-based denture ...
Jacob M Philip +2 more
doaj +1 more source
The Journal of Indian Prosthodontic Society, 2017 Aim: Various chemical solutions have been recommended for denture disinfection; however, the immersion effect on the properties of denture base resin may also have effect on strength of the resin material.
Rizwana Anjum +5 more
doaj +1 more source
Physical properties of heat cure denture base resin after incorporation of methacrylic acid
Contemporary Clinical Dentistry, 2018 Introduction: Heat cure acrylic resins are the most commonly used denture base materials. The important limitation is they may act as reservoir of microorganisms.
Kotha Sujitha +5 more
doaj +1 more source
The Rheological Properties of Fluid Denture-Base Resins [PDF]
Journal of Dental Research, 1978 The rheological properties of six commercial fluid denture resins were determined by rotational viscometry. Initial viscosity ranged from 67 to 575 centipoise at a rotational speed of 10 revolutions per minute. All resins showed initial non-Newtonian flow behavior and increased viscosity with time.
Vermilyea, S. G. +2 more
openaire +3 more sources
Advanced Intelligent Systems, Volume 7, Issue 3, March 2025.We demonstrate the direct‐laser patterning of a gold thin film on polymethyl methacrylate to fabricate a temperature sensor for dentures. The temperature sensor‐embedded smart dentures are evaluated in an oral environment, enabling in‐situ monitoring for elderly healthcare.
Han Ku Nam +7 more
wiley +1 more source
BMEMat, EarlyView.This study reports a novel Zr58Cu25Al14Nb3 bulk metallic glass that possesses high mechanical strength and low elastic modulus, which further promotes efficient mechanotransduction and significantly improves peri‐implant bone quality upon cyclic occlusal loading.
Yunshu Wu +10 more
wiley +1 more source
Five‐year tomographic and clinical evaluation of the socket shield technique: Case report
Clinical Advances in Periodontics, EarlyView.Abstract Background The socket shield technique, one modality of partial extraction therapy, aims to preserve periodontal tissues and maintain the buccal alveolar bone volume following immediate implant placement or in prosthetic pontic sites, by the strategic maintenance of a tooth root fragment.
Renan Dalla +3 more
wiley +1 more source