Results 131 to 140 of about 224,478 (288)

Deposition of Diamond-like Carbon and Carbyne Thin Film by Cathodic Plasma Electrolysis Process

Journal of Advanced Materials in Engineering, 2018
By using cathodic plasma electrolysis, a thin film of diamond-like carbon and carbyne was produced on the  nickel surface. The ethanolic solution at different concentrations of 15, 30 and 50 vol% was used as the  electrolyte; the  produced carbon film ...
A. Habibi, S.M. Mousavi Khoie, F. Mahboubi   +2 more
doaj  

Using a Zero‐Strain Reference Electrode to Distinguish Anode and Cathode Volume Changes in a Solid‐State Battery

Advanced Materials Interfaces, EarlyView.
Volume changes of a solid‐state battery cell are separated into the individual contributions of anode and cathode. Simultaneously determining the “reaction volumes” of both electrodes requires a reference electrode with a pressure‐independent potential.
Mervyn Soans, Benedikt Huber, Marcel Drüschler, Dominic Bresser, Alberto Varzi, Christoffer Karlsson   +5 more
wiley   +1 more source

Biocompatibility of Antifogging SiO-doped Diamond-Like Carbon Laparoscope Coatings. [PDF]

Appl Surf Sci, 2023
Leonard RL, Bull AB, Xue F, Haycook CP, Gray SK, Bond CW, Bond PE, McDearman JC, Woods DP, Mayfield J, Brown LR, Giorgio TD, Johnson JA.   +12 more
europepmc   +1 more source

Dual ion beam deposition of carbon films with diamondlike properties [PDF]

A single and dual ion beam system was used to generate amorphous carbon films with diamond like properties. A methane/argon mixture at a molar ratio of 0.28 was ionized in the low pressure discharge chamber of a 30-cm-diameter ion source.
Angus, J. C., Mirtich, M. J., Swec, D. M.   +2 more
core   +1 more source

Investigation of Structural, Mechanical and Electrochemical Properties of Temperature‐Dependent Dual AlN/TiAlN Coating Synthesized by CVD Process

Advanced Materials Interfaces, EarlyView.
This study investigates thermally CVD‐deposited AlN/TiAlN dual‐layer coatings over a Si substrate, focusing on the temperature‐dependent process‐structure relationship. Systematic characterization reveals that a dense AlN interlayer combined with an optimally deposited TiAlN top layer provides enhancement in mechanical strength, tribological stability,
Soham Das, Abhishek Kundu, Debjyoti Sahu, Nikhil Kumar, Spandan Guha   +4 more
wiley   +1 more source

RF Magnetron Sputtered Tungsten Disulfide Films: Influence of Target Preparation, Deposition Parameters, and Storage Conditions on Thin Film Stoichiometry

Advanced Materials Interfaces, EarlyView.
Sputtered WS2 films were investigated in terms of their S‐ and O‐concentration depending on deposition power and pre‐sputter time. Chemical and structural investigations were done using EDS, TEM, SEM, AFM, XRD. In general, 20 W films exhibit a wide variation in stoichiometry and structure whereas 80 W films demonstrate a higher S/W ratio than 20 W ...
Theresa Scheler, Pascal Illgner, Thomas Kups, Michaela Blum, Peter Schaaf   +4 more
wiley   +1 more source

Comprehensive hemocompatibility analysis on the application of diamond-like carbon to ePTFE artificial vascular prosthesis. [PDF]

Sci Rep, 2023
Goyama T, Fujii Y, Muraoka G, Nakatani T, Ousaka D, Imai Y, Kuwada N, Tsuji T, Shuku T, Uchida HA, Nishibori M, Oozawa S, Kasahara S.   +12 more
europepmc   +1 more source

From Copper Nanoparticles to Alumina Encapsulated Porous Layers With Enhanced Mechanical Stability

Advanced Materials Interfaces, EarlyView.
This study analyzes the synthesis‐structure relation of individual Cu nanoparticles and highly porous nanoparticle‐based Cu films using different sputtering‐based nanoparticle sources. The inherent mechanical instability of the films is tackled with Al2O3 encapsulation through atomic layer deposition, enabling 4‐fold increase in critical force in ...
Dominik Gutnik, Daniele Casari, Laszlo Pethö, Michael Burtscher, Anna M. Hofer‐Roblyek, Christian Mitterer, Barbara Putz   +6 more
wiley   +1 more source

Diamond-like Carbon Patterning by the Submerged Discharge Plasma Technique via Soft Solution Processing. [PDF]

ACS Omega, 2023
Sahoo SK, Bolagam R, Sardar K, Kaneko S, Shi SC, Chang KS, Yoshimura M.   +6 more
europepmc   +1 more source

Development of Laterally Graded X‐Ray Multilayer Optics

Advanced Materials Technologies, EarlyView.
This work presents the development of laterally graded X‐ray multilayer optics with both constant and variable lateral gradients. By precisely controlling substrate speed profiles and mask design, these multilayers achieve highly accurate lateral gradients and excellent sagittal thickness uniformity, making them ideal for spectroscopy application at ...
Arindam Majhi, Wadwan Singhapong, Wai Jue Tan, Andrey Sokolov, Stefano Agrestini, Mirian Garcia‐Fernandez, Kejin Zhou, Andrew C. Walters, Chris Bowen, Alexander J.G. Lunt, Hongchang Wang, Kawal J. Sawhney   +11 more
wiley   +1 more source