Results 11 to 20 of about 345,268 (272)
Journal of Materiomics, 2021 BaTiO3-epoxy dielectric composites were prepared by curing the liquid epoxy monomer that infiltrated into the partially-sintered BaTiO3 porous ceramics.
Meng Cao +4 more
doaj
Dielectric anisotropy in polar solvents under external fields [PDF]
J. Stat. Mech. P08022 (2015), 2014 We investigate dielectric saturation and increment in polar liquids under external fields. We couple a previously introduced dipolar solvent model to a uniform electric field and derive the electrostatic kernel of interacting dipoles. This procedure allows an unambiguous definition of the liquid dielectric permittivity embodying non-linear dielectric ...
arxiv +1 more source
Dielectric properties of interacting storage ring plasmas [PDF]
Phys.Rev.E59:1015-1023,1999; Erratum-ibid.E69:039902,2004, 1998 A dielectric function including collisional correlations is derived by linearizing the self consistent Vlasov equation with a Fokker-Planck collision integral. The calculation yields the same type of dielectric function as in the standard-theory of Schottky-noise in storage rings. This dielectric function is compared with the Mermin-dielectric function
arxiv +1 more source
Energies, 2022 In this paper, the role of the accumulated surface charge on the surfaces of nanoparticles on breakdown strength for liquid and solid dielectrics is presented. The breakdown strengths of a nanofilled liquid dielectric and a solid dielectric are evaluated.
Mohamed E. Ibrahim +4 more
doaj +1 more source
Super Dielectric Materials [PDF]
, 2014 Evidence is provided that a class of materials with dielectric constants greater than 100,000, herein called super dielectric materials (SDM), can be generated readily from common, inexpensive materials.
arxiv +1 more source
Molecular Association Studies on Polyvinyl Alcohol at Different Concentrations
Advances in Materials Science and Engineering, 2018 Ultrasonic velocities, densities, and viscosities have been measured for the solution of polyvinyl alcohol in water at concentration range of 0.3% to 1% at temperature 35°C.
Richa Saxena, S. C. Bhatt
doaj +1 more source
Enhanced dielectric response and non-Ohmic properties of Ge-doped CaTiO3/CaCu3Ti4O12
Journal of Asian Ceramic Societies, 2022 We present a method for increasing the dielectric constant of CaTiO3/CaCu3Ti4O12 (CTO/CCTO) composites and retaining a low-loss tangent (tanδ) by doping with Ge dopant.
Jirata Prachamon +7 more
doaj +1 more source
Modeling of the evolution of dielectric loss with processing temperature in ferroelectric and dielectric thin oxide films [PDF]
, 2008 It was experimentally found that the evolution of dielectric loss with processing temperature displays a common trend in ferroelectric and dielectric thin oxide films: firstly an increase and then a decrease in dielectric loss when the processing temperature is gradually raised. Such a dielectric response of ferroelectric/dielectric thin films has been
arxiv +1 more source
Frequency-dependent dielectric function of semiconductors with application to physisorption [PDF]
Phys. Rev. B 95, 035203 (2017), 2016 The dielectric function is one of the most important quantities that describes the electrical and optical properties of solids. Accurate modeling of the frequency-dependent dielectric function has great significance in the study of the long-range van der Waals (vdW) interaction for solids and adsorption.
arxiv +1 more source
PIC Simulations of One-side Multipactor on Dielectric [PDF]
, 2022 Breakdown of dielectric RF windows is an important issue for particle accelerators and high-power RF sources. One of the generally considered reasons for the RF windows failure is the multipactor on dielectric surface. The multipactor may be responsible for excessive heating of dielectric and discharge of charges that accumulated in ceramic due to ...
arxiv +1 more source