Results 101 to 110 of about 119,781 (297)
Lattice dynamics and phonon characteristics of complex perovskite microwave ceramics
Complex perovskite microwave dielectric ceramics (MWDCs) of [inline-formula]-type (A = Ba, Sr,…; B′ = Mg, Zn,…; B″ = Nb, Ta), which exhibit excellent dielectric properties, have currently been widely used in microwave and millimetre wave devices ...
Feng Shi +7 more
doaj +1 more source
A food‐grade cooling composite made from starch and recycled eggshell powder offers a scalable, ultra‐low‐cost solution for passive daytime radiative cooling. Easily prepared using basic kitchen tools, this material empowers communities, even in areas with limited infrastructure, to stay cooler during worsening summer heat waves.
Qimeng Song +3 more
wiley +1 more source
Achieving high‐performance dielectric materials remains a significant challenge due to the inherent trade‐offs between high energy storage density and low energy loss.
Yipin Cheng +6 more
doaj +1 more source
The development of broadband, high-performance electromagnetic (EM) wave absorbers in the millimeter-wave (mmWave) band requires optimizing both magnetic and dielectric losses, presenting significant challenges.
Jae Ryung Choi +5 more
doaj +1 more source
In Situ Study of Resistive Switching in a Nitride‐Based Memristive Device
In situ TEM biasing experiment demonstrates the volatile I‐V characteristic of MIM lamella device. In situ STEM‐EELS Ti L2/L3 ratio maps provide direct evidence of the oxygen vacancies migrations under positive/negative electrical bias, which is critical for revealing the RS mechanism for the MIM lamella device.
Di Zhang +19 more
wiley +1 more source
EXICITATION OF WHISPERING GALLERY MODES IN A DISK PLANAR DIELECTRIC RESONATOR BY A COUPLING SLOT
The spectral and energy characteristics of disk planar dielectric resonator (DR) with high-order whispering gallery modes (WGMs) were investigated in Ka-band.
A, Ye. Kogut +4 more
doaj
This work presents a continuous linear gradient catalyst layer design, a general strategy for improving membrane electrode assemblies across electrochemical devices. Fabricated via a dual‐nozzle spray coating method, the architecture controls the Pt/carbon ratio, ionomer content and ionomer type across the catalyst layer, enhancing proton conduction ...
Shangwei Zhou +15 more
wiley +1 more source
This paper discussed the effect of frequency on dielectric properties of different weight fraction of Cu powder reinforced epoxy composite materials. Dielectric properties of epoxy material was reinforced with (0, 5, 15, 30, 45) % weight fraction of Cu ...
Walaa W. Jameel
doaj
Preparation and characterization of Bi4–xPrxTi3O12 solid solutions
The Bi4–xPrxTi3O12 (BPT) solid solutions (x = 0.05, 0.10, 0.15) with small praseodymium content were prepared by solid-state method. Thermal, electric, and dielectric properties of BPT were studied.
A. I. Klyndyuk +2 more
doaj +1 more source
Dielectric Losses of Doped Colored Crystals
The dielectric losses of KBr single crystals doped with BaBr2 at different concentrations, both uncolored and additively colored, have been measured. A maximum in the dielectric loss versus frequency curve in the additively colored crystal was observed. This relaxation maximum was found to be due to the presence of Z2 centers.
openaire +2 more sources

