Results 91 to 100 of about 24,359 (261)
Atomic Layer Deposition of Metallic Molybdenum Dioxide Thin Films Enabling High‐k Rutile Capacitors
Advanced Materials Interfaces, EarlyView.The first direct atomic layer deposition (ALD) process of molybdenum dioxide (MoO2) thin films is reported using molybdenum(II) acetate dimer (Mo2(OAc)4) and oxygen (O2) as precursors at 235°C–275°C. The films are crystalline, exceptionally pure, and conductive.
Alexey Ganzhinov +8 more
wiley +1 more source
High‐Sensitivity Terahertz Gas Sensing Enabled by Undercut Metal‐Dielectric‐Metal Metamaterial
Advanced Materials Interfaces, EarlyView.A terahertz (THz) metamaterial gas sensor is demonstrated using a metal–dielectric–metal (MDM) absorber with an undercut dielectric layer, which enlarges the gas‐replaced volume and strengthens refractive‐index perturbation of the resonant mode. A reflection dip at 0.766 THz is observed, and acetone–nitrogen tests yield concentration‐dependent shifts ...
Naoki Inomata +2 more
wiley +1 more source
Layered Nanoporous Platforms for SERS Sensing
Advanced Materials Interfaces, EarlyView.Here, we present a detailed investigation of the SERS performance of layered nanoporous metals. The controlled deposition of well‐defined, stacked porous layers enabled a systematic analysis of the effects of multimetallic systems in SERS experiments. Numerical models are also used to support the experimental findings.
Yanqiu Zou +18 more
wiley +1 more source
Advanced Materials Interfaces, EarlyView.Ultrathin MXene/EMF composite foams achieve a specific shielding efficiency of 749.6 dB.dB·cm3$\mathrm{dB}\cdot {\mathrm{cm}}^{3}$/g, while the silver‐enhanced MXene/Ag/EMF reaches 81.4 dB shielding effectiveness at just 1.0 mm thickness. Both composites exhibit rapid Joule heating, retain stability up to 250∘C$^\circ{\rm C}$, and withstand 1000 ...
Abdullah A. Mahmood +7 more
wiley +1 more source
Dielectric properties of poly(vinylidene fluoride)/CaCu3Ti4O12 nanocrystal composite thick films
eXPRESS Polymer Letters, 2010 The poly(vinylidene fluoride)/CaCu3Ti4O12 (CCTO) nanocrystal composite films (thickness ≈85 µm) with relatively high dielectric permittivity (90 at 100 Hz) were prepared by the solution casting followed by spin coating technique.
doaj +1 more source
Ultrahigh dielectric permittivity in oxide ceramics by hydrogenation. [PDF]
Sci Adv, 2023 Duong NX +19 more
europepmc +1 more source
Advanced Materials Interfaces, EarlyView.MAPbBr3/rGO hybrids exhibit interfacial electronic restructuring that enhances charge extraction in photodetectors. The incorporation of rGO modifies the surface chemical environment, enhances electron‐dominated transport, and suppresses performance degradation, resulting in higher responsivity, detectivity, and photostability than in pristine MAPbBr3 ...
Mohammed Misbah Uddin +4 more
wiley +1 more source
IEEE AccessThe 3D-printing of dielectric superstrates of Resonant Cavity Antennas has advantages of fast prototyping and flexibility in the realization of customized layouts. In this work, the low dielectric permittivity of test filaments is experimentally measured
Cristina Ponti +3 more
doaj +1 more source
Temperature-dependent complex dielectric permittivity: a simple measurement strategy for liquid-phase samples. [PDF]
Sci Rep, 2023 Baker-Fales M +3 more
europepmc +1 more source
Light Switchable Ionic Conductivity of Arylazopyrazole Modified Polysiloxanes
Advanced Materials Technologies, EarlyView.We present a polysiloxane functionalized with a novel arylazopyrazole dye that undergoes reversible photoisomerization. Upon lithium bis(trifluoromethanesulfonyl)imide addition and UV irradiation, the polymer exhibits a shift in tan(d) toward higher frequencies and enhanced ionic conductivity.
Malte S. Beccard +7 more
wiley +1 more source