Results 61 to 70 of about 61,629 (315)
Diesel engine fuel injection monitoring using acoustic measurements and independent component analysis [PDF]
Air-borne acoustic based condition monitoring is a promising technique because of its intrusive nature and the rich information contained within the acoustic signals including all sources.
Gu, Fengshou +7 more
core +1 more source
Graphical representation of a data‐driven framework for Fischer‐Tropsch synthesis (FTS) modelling and optimization. Abstract This study presents a data‐driven approach for predicting the relationships between catalyst design, process conditions, and product selectivity in Fischer–Tropsch synthesis (FTS).
Doaa M. Hassan +2 more
wiley +1 more source
This paper investigates the small-signal stability of a DC shipboard power system (SPS) with the integration of a supercapacitor. As an efficient energy storage solution, supercapacitors can not only provide rapid energy response to sudden power demand ...
Qinsheng Yun +4 more
doaj +1 more source
In order to protect the marine environment, the fuel cell has become a good candidate for the main energy source of marine vehicles due to its remarkable performance of high efficiency, quietness, and cleanness. However, the fuel cell of the hybrid power
Zehui Zhang, Cong Guan, Zhiyong Liu
doaj +1 more source
Emission Characteristics of a CI Engine Running with a Range of Biodiesel Feedstocks
Currently, alternative fuels are being investigated in detail for application in compression ignition (CI) engines resulting in exciting potential opportunities to increase energy security and reduce gas emissions.
Gu, Fengshou +7 more
core +1 more source
Lithium carbonate (Li2CO3) obtained from the black mass of recycled lithium batteries is dissolved in water under controlled conditions to remove lithium fluoride (LiF), which is present at a concentration of 3.08 % by weight. The dissolution is carried out at temperatures below 10 °C, and it has been demonstrated that lower temperatures result in ...
Laura Rosso +3 more
wiley +1 more source
Ammonia Concentration Control in Selective Reduction Systems of Nitrogen Oxides of Diesels
Reduction of toxic components in the exhaust gas of diesel engines to the level of the requirements of Euro 6 is a socially important and technically complex problem.
Alexey A. Demidov +2 more
doaj
Dynamic Evaluation Method of Machining Process Planning Based on Digital Twin
Process evaluation is widely accepted as an effective strategy to improve product quality and shorten its development cycle. However, there has been very little research on how to evaluate the process plan with the dynamic change of the machining ...
Jinfeng Liu +6 more
doaj +1 more source
NOx Emission Prediction Based on Measurement of in-Cylinder Pressure for CI Engine Running with Diesel and Biodiesel [PDF]
NOx is one of the major toxic emissions that needs to be regulated stringently in both EU and USA emission regulations. The engine designer is keen to get an accurate, reliable and cost effective NOx measurement system.
Gu, Fengshou +4 more
core
Carbon emission assessment of tunnel infrastructures: From construction to operation
This study develops a lifecycle carbon accounting framework for tunnel infrastructures, covering design, construction, operation, maintenance, and dismantling. Applied to a subsea tunnel case, the framework reveals the carbon emission distribution among four typical tunnel types and highlights potential carbon offset methods for low‐carbon tunnel ...
Luyuan Long +4 more
wiley +1 more source

