Results 31 to 40 of about 518 (155)
The problem of constructing the multilevel physical model of inelastic deformation in steels allowing to take into consideration diffusionless solid-state phase (martensitic) transitions is considered.
Nikita Sergeevich Kondratev +2 more
doaj +3 more sources
Composition of ω-Phase Particles in Ti(Mo) Alloys Studied by Anomalous X-ray Diffraction
Nanoparticles of hexagonal ω phase in bcc-Ti(Mo) single crystals ( β phase) occur due to a diffusionless athermal β to ω transformation and they grow during follow-up ageing at elevated temperatures, while the ...
Jana Šmilauerová +3 more
doaj +1 more source
Harnessing Bifunctional Nitrogen-Dislocation Interactions for a Record Ultra-Strong-and-Ductile Duplex Titanium Alloy. [PDF]
By engineering bifunctional nitrogen‐dislocation interactions, this work constructs a heterogeneous lamellar structure with N‐rich low‐angle boundaries and coherent nanotwinned martensites, enabling ultrahigh yield/tensile strength (1532/1869 MPa) and activating massive
Zhang C +5 more
europepmc +2 more sources
The current work focuses on complex multiphase microstructures gained in CrMo medium carbon steel after ultra-fast heat treatment, consisting of heating with heating rate of 300 °C/s, 2 s soaking at peak temperature and subsequent quenching. In order
Spyros Papaefthymiou +3 more
doaj +1 more source
Temperature‐dependent electron diffraction on tin monochalcogenides demonstrates a gradual displacive transformation between ferroelectric and paraelectric phases with significant variability in lattice constants and Curie temperature (TC). Periodic variations exist even between domains in individual crystals, implying a domain‐specific Curie ...
Peter Sutter, Eli Sutter
wiley +1 more source
ABSTRACT Diffusion bonding (DB) of near‐α titanium alloys requires high temperatures, which can cause grain coarsening, structural deformations, and degradation of the workpiece's mechanical characteristics. In this study, thermal hydrogen processing (THP) was applied to Ti65, combined with selective magnetron sputtering of a Ti‐Al thin film to promote
Liang‐Wei Kang +9 more
wiley +1 more source
This study validates a recycling pathway for converting interconnect assemblies from end‐of‐life SOC stacks into commercial‐grade AISI 304 steels. Using scrap‐based steelmaking operations, austenitic cast steels with <4.0% δ‐ferrite are successfully produced.
Jeraldine Lastam +7 more
wiley +1 more source
High Pressure Formation of the Eight‐Fold Coordinated Post‐Post Spinel MgFe2O4
Abstract MgFe2O4 was probed to 74(1) GPa and 2,840(130) K as a low‐pressure analog to post‐post spinel Mg2SiO4 predicted in super‐Earths using synchrotron multigrain X‐ray diffraction techniques in the laser‐heated diamond anvil cell. With high‐temperatures above 65 GPa the eight‐fold coordinated δ‐MgFe2O4 (Th3P4‐type) is stable with Mg and Fe ...
Claire C. Zurkowski +4 more
wiley +1 more source
Constitutive modeling of the slip-twinning transition in martensitic transformations
Martensite is the result of a diffusionless displacive phase transition. In Fe-based alloys it transforms the FCC to the BCC, BCT, or HCP structures and occurs at high strain rates. It has two typical morphologies, known as lath and plate. A quantitative
Sheron Stephany Tavares +1 more
doaj +1 more source
Heat Capacity Measurements and Thermodynamic Assessment of the Y2O3–Ta2O5 System
ABSTRACT Phase equilibria in the Y2O3–Ta2O5 system play an important role in the development of new materials for thermal barrier coating (TBC) applications, with higher thermal stability resulting in more efficient gas turbines with reduced exhaust gas emissions.
M. Löffler +4 more
wiley +1 more source

