Results 171 to 180 of about 3,004,176 (304)
This article presents the NFDI‐MatWerk Ontology (MWO), a Basic Formal Ontology‐based framework for interoperable research data management in materials science and engineering (MSE). Covering consortium structures, research data management resources, services, and instruments, MWO enables semantic integration, Findable, Accessible, Interoperable, and ...
Hossein Beygi Nasrabadi +4 more
wiley +1 more source
Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
MS360°: a conceptual digital-first, data-driven hybrid care framework for personalised multiple sclerosis management. [PDF]
Voigt I +5 more
europepmc +1 more source
Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Social Media Promotion of Raw Date Palm Sap and Emerging Nipah Virus Transmission Risk in Bangladesh: Descriptive Analysis of Multisource Data. [PDF]
Chowdhury KIA +27 more
europepmc +1 more source
Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V
Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena +2 more
wiley +1 more source
Screening the Digital Skills of Patients in Geriatric Rehabilitation: Multicenter Cross-Sectional Study. [PDF]
Zonneveld MB +4 more
europepmc +1 more source
Evaluating Energy Absorption Performance of Filled Lattice Structures
Maximum stress must be considered to robustly evaluate energy absorber designs. This approach was applied to compare all types of absorbers in a single Ashby diagram and determine the utility of filling lattice voids with a second material. High‐performance fillers can improve the performance of lattices that are limited by buckling or catastrophic ...
Christian Bonney +2 more
wiley +1 more source
The Brazilian Labour Court Digital Collection
Larissa Rosa Corrêa
doaj +1 more source
Gi-MAPS: a quantitative engineering framework for AI-guided pediatric gut microbiome ecological interpretation and digital-twin simulation. [PDF]
Wang X +6 more
europepmc +1 more source

