Results 111 to 120 of about 1,096,635 (280)
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
Critical Public Health, 2014 Foucault uses the term ‘biopower’ to describe the totalizing effects of regulation of life through the manipulation of political messages, such as those in the obesity debate. This paper attempts to uncover ways in which these flows are made manifest among members of a public online weight loss surgery (WLS) discussion forum.
Matthew D. Ferry, Centáe Richards
openaire +1 more source
Towards Defect Phase Diagrams: From Research Data Management to Automated Workflows
Advanced Engineering Materials, EarlyView.A research data management infrastructure is presented for the systematic integration of heterogeneous experimental and simulation data required for defect phase diagrams. The approach combines openBIS with a companion application for large‐object storage, automated metadata extraction, provenance tracking and federated data access, thereby supporting ...
Khalil Rejiba +5 more
wiley +1 more source
The Helper-Therapy Principle Applied to Weight Management Specialists
, 1983 One hundred twenty applicants to a weight management specialist training program were studied over a 33-month period. Following a nine-month training period, Specialists (N = 29; those leading at least one posttraining weight management group) were ...
Katahn, Martin +3 more
core
"Gravitational mass" of information?
, 2008 We hypothesize possible new types of forces that would be the result of new types of interactions, static and a slow transient, between objects with related information contents (pattern). Such mechanism could make material composition dependence claimed
Kish, Laszlo B.
core +1 more source
Advanced Engineering Materials, EarlyView.This study reports lightweight polyetherimide triply periodic minimal surfaces lattices coated with carbon nanotube‐reinforced epoxy that combine mechanical robustness with self‐sensing. The conformal coating enhances stiffness, strength and energy absorption while enabling reliable strain monitoring.
A. Triay +3 more
wiley +1 more source
Personalized versus generic digital weight loss interventions delivered on university campuses: a 6-month cost-benefit analysis. [PDF]
Transl Behav Med, 2023 Napolitano MA +8 more
europepmc +1 more source
Poly(Methyl Methacrylate), Polypropylene and Polyethylene Nanocomposite Formation by Melt Blending using Novel Polymerically-Modified Clays [PDF]
, 2004 Two new organically-modified clays that contain an oligomeric styrene or methacrylate have been prepared and used to produce nanocomposites of poly(methyl methacryate), polypropylene and polyethylene.
Jiang, David D. +2 more
core +1 more source
Advanced Engineering Materials, EarlyView.Additive manufacturing provides precise control over the placement of continuous fibres within polymer matrices, enabling customised mechanical performance in composite components. This article explores processing strategies, mechanical testing, and modelling approaches for additive manufactured continuous fibre‐reinforced composites.
Cherian Thomas, Amir Hosein Sakhaei
wiley +1 more source