Results 91 to 100 of about 1,294 (131)

Micro-Texturized and Ultra-Soft Dry Electrode for Motion-Artifact Tolerant and Long-Term Stable Wearable Electrophysiological Monitoring. [PDF]

Small
Kim SM, Jang HJ, Kim KH, Hwang YJ, Lee YB, Jeong J, Jung S, Jeong E, Han DW, Sung ES, Seo MH.   +10 more
europepmc   +1 more source

Tapered Pillar Design for High-Precision Force Readout in Miniaturized Engineered Heart Tissues From Human Pluripotent Stem Cells. [PDF]

Adv Healthc Mater
Dostanić M, Wiendels M, Windt LM, Mol MPH, van den Hil FE, Davis RP, Orlova V, van Meer BJ, Mastrangeli M, Mummery CL.   +9 more
europepmc   +1 more source

Some of the next articles are maybe not open access.

Related searches:

1243. Dimethylpolysiloxanes exonerated

Food and Cosmetics Toxicology, 1967
exaly   +2 more sources

The determination of dimethylpolysiloxane in beer and yeast

The Analyst, 1971
An infrared method that provides an estimate of the silicone content of beer and yeast has been developed. Because of the increased sensitivity over other reported methods it is possible to use smaller samples, which could be an advantage with biological material. The recommended working concentration range is 0·2 to 2 mg 1–1.
A, Sinclair, T R, Hallam
openaire   +2 more sources

Determination of dimethylpolysiloxanes in fats and oils

JAOCS, Journal of the American Oil Chemists' Society, 1980
AbstractA direct aspiration, flame atomic absorption method has been developed for the determination of dimethylpolysiloxanes (DMPS) in fats and oils. The detection limit of the method is approximately 1 ppm with a standard deviation for samples containing 1–10 ppm DMPS of 0.3. The technique is reasonably rapid, requires a minimum of sample preparation,
W. G. Doeden, E. M. Kushibab, A. C. Ingala   +2 more
exaly   +2 more sources

Effect of A Dimethylpolysiloxane Fluid on the Stability of Menadione

Journal of Pharmaceutical Sciences, 1968
The nonaqueous solvents presently in use as parenteral vehicles possess certain disadvantages or have limited application. The silicone fluids have certain physical, chemical, and biological properties which would appear to make them suitable for parenteral formulations.
R T, Turnbull, K E, Avis
openaire   +2 more sources

Thermal stability of chlorinated dimethylpolysiloxanes

Thermochimica Acta, 1975
exaly   +2 more sources

Dimethylpolysiloxane-reinforced film in a membrane oxygenator

Biomedical Engineering, 1977
With the purpose of diffuse membranous oxygenation of blood the possibility of employing a Soviet-made dimethylpolyxyloxane-reinforced film "Sigma" was investigated. The test-trials were carried out with a membranous oxygenator of the "Sandwich" type.
I S, Kurapeev, V N, Vavilov, Iu S, Zatepiakin, S I, Rotenburg, M P, Grinblat   +4 more
openaire   +2 more sources

Viscometric properties of salicyloxymethyldimethyl end-blocked dimethylpolysiloxanes

Journal of Polymer Science, 1957
AbstractViscometric data obtained over a temperature range of 0–150°C. for a series of salicyloxymethyldimethyl end‐blocked dimethylpolysiloxane fluids have shown that the molecular weight at which a minimum viscosity is exhibited is temperature‐dependent.
Robert L. Merker, Mary Jane Scott
exaly   +2 more sources

Thin-film deposition by laser ablation of dimethylpolysiloxane

Applied Surface Science, 2002
Abstract Transparent, well-insulated SiO2 thin films were deposited at room temperature by pulsed laser deposition with a dimethylpolysiloxane target. It could be asserted with confidence that the films deposited at the oxygen gas pressure of 4.4×10−2 Torr were to be SiO2 by X-ray photoelectron spectroscopy (XPS). The XPS analyses also supported that
Masayuki Okoshi, Masaaki Kuramatsu, Narumi Inoue   +2 more
openaire   +1 more source