Results 51 to 60 of about 113,564 (292)
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
Design of Cable Termination for AC Breakdown Voltage Tests
Energies, 2019 International standards prescribe overvoltage tests to evaluate the insulating material performance of high-voltage cables. However, it is difficult to manage the electric fields at the cable ends when laboratory measurements are carried out because ...
Arthur F. Andrade +4 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study investigates the tribological response of 60NiTi alloy under dry, water‐lubricated and high‐temperature conditions. The alloy exhibits decreasing wear volume and friction with increasing temperature due to the formation of protective oxide layers. The work clarifies dominant wear mechanisms and demonstrates the suitability of 60NiTi for high‐
Anthony Onyebuchi Okoani +2 more
wiley +1 more source
Influence of Electric Discharges on Bearings of Electric Machina
Advances in Electrical and Electronic Engineering, 2008 Bearing currents are one of cause’s bearings faults. The character of a lubricator belongs to main factor influencing an inception of bearing currents. We have analyzed the electric character variety kind of lubricators; the influence of lubricators on a
Jiri Foldyna +2 more
doaj
Microorganisms, 2021 Phycocyanin is a blue colored pigment, synthesized by several species of cyanobacteria and red algae. Besides the application as a food-colorant, the pigmented protein is of high interest as a pharmaceutically and nutritionally valuable compound.
Marie-Christine Sommer +5 more
doaj +1 more source
Method and device for detection of a substance [PDF]
, 1982 A device is disclosed in which a discharge grid is provided that has a sufficiently high voltage potential across its grid electrodes so that a substance with predetermined characteristics causes an electric spark discharge to occur between electrodes ...
Yang, L. C.
core +1 more source
Technological Aspects: High Voltage
, 2014 This paper covers the theory and technological aspects of high-voltage design for ion sources. Electric field strengths are critical to understanding high-voltage breakdown.
Faircloth, D. C.
core +1 more source
Current Flow and Pair Creation at Low Altitude in Rotation Powered Pulsars' Force-Free Magnetospheres: Space-Charge Limited Flow [PDF]
, 2012 (shortened) We report the results of an investigation of particle acceleration and electron-positron plasma generation at low altitude in the polar magnetic flux tubes of Rotation Powered Pulsars, when the stellar surface is free to emit whatever charges
A. N. Timokhin +45 more
core +3 more sources
Advanced Engineering Materials, EarlyView.Stabilization of L‐PBF Ni50.7Ti49.3 under low‐cycle loading was investigated. Recoverable strain after cycling was dependent on the amount of applied load. Recovery ratio was 53.4% and 35.1% at intermediate and high load, respectively. The maximum total strain reached 10.3% at a high load of 1200 MPa.
Ondřej Červinek +5 more
wiley +1 more source
Influence of Electric Discharges on Bearings of Electric Machines
Advances in Electrical and Electronic Engineering, 2006 I the last time many articles were found out discussed about shaft voltage, bearing currents and their influence on lifetime and reliability of electric machines bearings.
Karel Chmelik, Vaclav Cech, Jiri Foldyna
doaj