Results 31 to 40 of about 1,873 (236)
One of the most common issues in inverters are open-circuit faults (OPF). In this scenario, a proper fault-tolerant technique must be used to improve the motor performance.
Markel Fernandez +4 more
doaj +1 more source
Reductive Transformation of ALD TeO<sub>2</sub> into Continuous and Impurity-Free Tellurium Films. [PDF]
Atomic layer deposition forms a conformal TeO2 template that transforms to elemental Te through TeH2 mediated reduction using Te(SiMe3)2 and NH3. The transformation is self‐limiting and yields continuous crystalline Te with oxygen‐free bulk and interface even at ultrathin thicknesses.
Ryu SH +9 more
europepmc +2 more sources
A Study on Performance and Characteristic Analysis According to the Operating Point of IPMSM Drive
This study presents the characteristics and performance of a motor at the operating point based on pulse-width modulation (PWM). PWM is used in modulating the output voltage of a three-phase inverter.
Hyun-Jong Park +2 more
doaj +1 more source
International audienceThis paper deals with a developed pulse-width modulation technique for a Z-source three-level NPC inverter. This technique overcomes the limitation of the boost capability of the Z-source NPC inverter; hence, it may suit ...
Tabbache, Bekheïra +3 more
core +1 more source
: Multilevel modulation strategy is an important factor affecting the output performance of multilevel converters. In this paper, the relationship between phase-shifted pulse width modulation (PWM) and phase disposition PWM is analyzed, and then an ...
Muxuan Xiao, Qianming Xu, Honglin Ouyang
doaj +1 more source
Discontinuous pulse width modulation (DPWM) strategies are usually adopted to reduce the switching loss and output current ripple of three-phase three-level traction inverters under three-phase load conditions. However, if there is a short circuit in any
Guozheng Zhang +5 more
doaj +1 more source
Ultrathin lithium metal anodes (≤15 µm) offer a promising route to high‐energy‐density batteries due to their high capacity and low potential. This review presents design principles for ultrathin Li, evaluates fabrication strategies, and discusses challenges in liquid and solid‐state cells.
Cheng Wang +9 more
wiley +1 more source
This manuscript proposes a novel approach for determining phase and neutral-current-ripple RMS in grid-connected four-leg inverters with the neutral inductor.
Riccardo Mandrioli +3 more
doaj +1 more source
Femtosecond‐Laser Mould Texturing Enables Tunable Biointerfaces in COC Microfluidics
Femtosecond‐laser texturing of injection‐mould inserts enables scalable engineering of biointerfaces in cyclic olefin copolymer microfluidics. Replicated micro‐ and nano‐topographies modulate surface roughness and wettability, leading to texture‐dependent protein adsorption and cell adhesion without chemical post‐processing.
Irene Varela‐Leniz +9 more
wiley +1 more source
The key issue in the implementation of the Sliding Mode Control (SMC) in analogue circuits and power electronic converters is its variable switching frequency.
Abdul Rehman Yasin +2 more
doaj +1 more source

