Results 101 to 110 of about 386,467 (345)
Journal of the Belgian Society of Radiology, 2014 A 38 year-old patient was admitted to the emergency department after road accident due to pain on palpation of the right wrist, the 1st and the 2nd finger of the right hand. The patient was subsequently referred for an X-ray. Following the proper positioning of the patient and the systematic analysis of the wrist X-ray (PA and lateral view), a lunate ...
Filippitzi, Fotini +6 more
openaire +6 more sources
Dynamic Precipitation during High‐Pressure Torsion of a Magnesium–Manganese Alloy
Advanced Engineering Materials, EarlyView.An ultrafine‐grained alloy is produced by high‐pressure torsion of solutionized Mg–1.35 wt% Mn. Precipitation of nanometer‐scale Mn particles during deformation provides pinning sites. This prevents the formation of a bimodal grain structure and results in a finer grain size than for pure Mg.
Julian M. Rosalie, Anton Hohenwarter
wiley +1 more source
Dislocations in Crystalline Silicon Solar Cells
Advanced Energy & Sustainability ResearchDislocation is a common extended defect in crystalline silicon solar cells, which affects the recombination characteristics of solar cells by forming deep‐level defect states in the silicon bandgap, thereby reducing the lifetime of minority carrier ...
Libo Wang +12 more
doaj +1 more source
Dislocation propagation versus dislocation nucleation [PDF]
Nature Materials, 2006 E, Ma, T D, Shen, X L, Wu
openaire +2 more sources
Laser Metal Deposited Ti4822 Hollow Pipe: Experimental and Computational Modelling Study
Advanced Engineering Materials, EarlyView.Laser metal deposition (LMD) of a crack‐free built Ti4822 alloys is challenging. This article reports outstanding characteristics of a hollow pipe that is built with LMD technology when a predicted, nontransformation substrate temperature of 800 °C is used.
Sadiq A. Raji +5 more
wiley +1 more source
Interfacial screw dislocations in anisotropic two-phase media [PDF]
, 1973 Y. T. Chou, C. S. Pände
openalex +1 more source
Advanced Engineering Materials, EarlyView.The effect of temperature controllers that are commonly used in freeze‐casting is investigated in this work. Temperature controllers are observed to generate a voltage in the slurry. Microstructural alignment and ultimate compressive strength data show this voltage to interfere with the ability to align the microstructure using magnetic fields ...
Maddie A. Schmitz, Steven E. Naleway
wiley +1 more source
Advanced Engineering Materials, EarlyView.This study investigates laser shock peening for enhancing fatigue performance of riveted aerospace aluminum joints. A comparative approach with cold expansion combines fatigue testing and synchrotron X‐ray methods. Integrating mechanical testing with residual stress and strain characterization provides insights into how different treatments affect the ...
Ogün Baris Tapar +6 more
wiley +1 more source
Critical Care Management of Fracture Dislocation of Cervical Spine: A Case Report
, 2023 Liliriawati Ananta Kahar +3 more
openalex +2 more sources
Advanced Engineering Materials, EarlyView.Al‐Cu intermetallic compounds (IMCs) have a significant influence on the properties of Al‐Cu bimetallic interfaces formed in compound casting. This article provides a deeper understanding of microstructure, crystallography, thermal properties, hardness, and corrosion response of Al‐Cu IMCs with the goal of facilitating the optimization of the ...
Alireza Nazarahari +7 more
wiley +1 more source