Results 61 to 70 of about 5,894,910 (159)
Thermal influence of welding process on strength overmatching of thin dissimilar sheets joints [PDF]
The investigation addresses the overall performance of black and white joints (BWJ) of low carbon steel and stainless steel thin sheets achieved by laser hybrid welding.
Iordachescu, Danut +4 more
core
Paint baking of resistance spot welded joints of 2.0 GPa warm‐stamped medium‐Mn steel activates low‐temperature tempering, forming fine cementite in the fusion zone and enhancing toughness. Crack propagation resistance increases, shifting the failure mode from partial interfacial to complete pullout, with peak load and energy absorption rising ...
Sunusi Marwana Manladan +8 more
wiley +1 more source
This study aims to determine the effect of variations of the current with combining two welding techniques SMAW and FCAW in double v-groove against the hardness and microstructure of the dissimilar material of JIS G3101-SS400 and ASTM A36.
Jatmoko Awali +5 more
doaj +1 more source
Prediction and optimization of residual stresses, weld-bead profile and mechanical properties of laser welded components [PDF]
Recently, laser welding has become a leading industrial joining process. Mainly because it has become highly automated using sophisticated robotic systems. However, to make effective use of automated laser welding it is essential to have a high degree of
Benyounis, Khaled
core +2 more sources
The high‐strain‐rate behavior of resistance spot‐welded DP800–DP1000 joints is investigated. Results show that microstructural gradients across BM–HAZ–FZ govern hardness, strain rate sensitivity, and failure modes. While strength increases with strain rate, energy absorption is controlled by ductility, with DP800–DP800 joints showing superior ...
Pankaj Shrivastava, Velaphi Msomi
wiley +1 more source
Joining of automotive sheet materials by friction-based welding methods: A review
The demands for higher fuel efficiency in the automotive sector have motivated the increased use of multi-material combinations for lightweight designs in recent years.
M. Haghshenas, A.P. Gerlich
doaj +1 more source
This manuscript presents a study on the effects of parameter control of low‐voltage pulsed‐GMA‐AM application for producing 309LSi multilayered build‐ups, which can simultaneously lead to reduced heat input up to 32.1%, enable pulsed‐spray transfer, provide stable depositing conditions and preserve dimensional consistency, favoring fabrication of a 114‐
Petrônio L. C. C. C. Fernandes +4 more
wiley +1 more source
Spectroscopic Studies of dissimilar Al-Cu laser welding
peer reviewedThis paper describes a novel method to analyze the effect of the fiber laser induced plasma on welding of dissimilar Al and Cu. Based on spectroscopic studies, specific wavelengths were found to be suitable for process monitoring during ...
SCHMALEN, Pascal Guy +3 more
core +2 more sources
ABSTRACT Dynamic multi‐objective evolutionary algorithms (DMOEAs) are widely used to solve dynamic multi‐objective optimisation problems. However, most existing DMOEAs rarely consider the severity of environmental changes and the varying impact of these changes on different decision variables, which restricts their applicability in complex dynamic ...
Yaru Hu +8 more
wiley +1 more source
Butt fusion welding of polyethylene pipes [PDF]
This thesis was submitted for the degree of Doctor of Philosophy and awarded by Brunel University.The butt fusion process is extensively used in the joining of polyethylene (PE) pipes by the water and gas industries.
Rashid, Haroon
core +4 more sources

