Results 161 to 170 of about 35,965 (255)

Association between urinary heavy metals, phthalates, phytoestrogens, and polycyclic aromatic hydrocarbons and endometriosis: A cross-sectional study from NHANES 1999 to 2016. [PDF]

Medicine (Baltimore)
Dong Y, Qiu J, Yang M, Wang W, Tong Z.
europepmc   +1 more source

Synthesis of a Novel Amine‐Based Curing Agent for Epoxy Resins Derived From Vanillin

Journal of Applied Polymer Science, EarlyView.
The four‐step synthesis of a new bio‐based amine hardener is described starting from vanillin as a bio‐based compound. The hardener ADBA was utilized to cure DGEBA and the resulting Tg,tanδmax was determined via DMA. Compared to other bio‐based curing agents, our curing agent is obtainable in a high yield and leads to a superior Tg of 135°C.
Bastian Hahn, Gerd Wehnert, Elisabeth Schamel, Dominik Söthje   +3 more
wiley   +1 more source

High Value-Added Secondary Raw Material From Winemaking Waste Bentonite to Design Antioxidant Pectin-Based Mucoadhesive Buccal Films. [PDF]

ChemistryOpen
Di Prima G, La Mantia C, De Caro V.
europepmc   +1 more source

Long‐Time Thermal Aging of Perfluoroalkoxy Polymers for Electrical Insulation: Structural and Physical Properties Evolutions

Journal of Applied Polymer Science, EarlyView.
This work focuses on the investigation of the influence of a long‐time exposition to accelerated thermal aging on the physicochemical structure and properties of PFA. Results show a decrease in the melting temperature and crystal ratio due to chemical aging.
Victor Henri, Julien Chedaille, Pierre Henrard, Eric Dantras   +3 more
wiley   +1 more source

Hydrogen Transport, Viscoelastic Drift, and Multiscale Characterization Framework for Elastomeric Seals Under High-Pressure Hydrogen. [PDF]

Polymers (Basel)
Subedi N, Bhuiyan MMH, Becerril Corral A, Gautam O, Islam MA, Siddique Z.   +5 more
europepmc   +1 more source

Wood Sawdust as a Low‐Cost Filler in Whole‐Tire Reclaimed Rubber: Mechanical Characterization and Factory‐Scale Cost Analysis

Journal of Applied Polymer Science, EarlyView.
Whole‐tire reclaimed rubber is upgraded with wood sawdust, a carpentry by‐product available at no cost, across loadings from 0 to 20 wt%. At 5 wt%, tensile strength, elongation, hardness, viscosity, and water absorption all stay within commercial specification, and real factory data show an annual production saving near $62,000 with no capital ...
Mohammed S. Matar, Faris Tarlochan, Sami E. Alkhatib, Abdullah Abdelhamid   +3 more
wiley   +1 more source

patRoon 3.0: Enhanced non-target analysis workflows with ion mobility separation and other major improvements

Helmus R, Specker JC, Gallampois C, Schymanski EL.   +3 more
europepmc   +1 more source

A Denoising Preprocessing Framework via Orthogonal Multi-Tap Null-Steering Beamformer Bank: Facilitating Target Signal Preservation Under Low SINR Conditions and Complex Soundscapes. [PDF]

Sensors (Basel)
Chen L, Xu Z, Su P, Zhao Z.
europepmc   +1 more source

Material Characterization of Lignin‐Filled Polypropylene Composites

Journal of Applied Polymer Science, EarlyView.
Ground and spray‐dried lignin powders are compared as fillers for polypropylene composites. Differences in powder preparation methods are associated with differences in powder characteristics and composite behavior after melt compounding. Spray‐dried lignin produces smaller particles and fewer large agglomerates, while a 5 wt% lignin loading provides a
Sungjun Hwang, Stefan N. E. Johansson II, Yousoo Han, Douglas J. Gardner   +3 more
wiley   +1 more source