Results 91 to 100 of about 380,799 (299)

Danube River discharge at Bezdan gauging station (Serbia) and its correlation with atmospheric circulation patterns [PDF]

open access: yesGeographica Pannonica, 2019
For understanding hydroclimatological process chain it is crucial to identify relations between large-scale climatic circulations and river discharge. The Danube is one of the most important European waterways, flowing 2.857 kilometers across the Europe ...
Dolinaj Dragan   +4 more
doaj  

Long-Term Temporal Variability of the Freshwater Discharge and Water Levels at Patos Lagoon, Rio Grande do Sul, Brazil

open access: yesInternational Journal of Geophysics, 2012
The aim of this study is to investigate the importance of freshwater discharge as a physical forcing in Patos Lagoon at timescales longer than one year, as well as identify the temporal variability of the dominant processes in freshwater discharge and ...
G. P. Barros, W. C. Marques
doaj   +1 more source

Corrosion and Process Analysis of a Preoxidized MgO Recyclate‐Based Cermet Anode in Laboratory‐Scale Na‐Cryolite Molten Salt Electrolysis of Aluminum at 1000°C

open access: yesAdvanced Engineering Materials, EarlyView.
EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk   +7 more
wiley   +1 more source

Higher dominant muscle strength is mediated by motor unit discharge rates and proportion of common synaptic inputs

open access: yesScientific Reports
Neural determinants explaining the asymmetrical force and skill observed in limb dominance still need to be comprehensively investigated. To address this gap, we recorded myoelectrical activity from biceps brachii using high-density surface ...
Edoardo Lecce   +4 more
doaj   +1 more source

Interaction of MgO Recyclate‐Based Cermet Anode With KF‐AlF3‐Al2O3 at 800°C During Laboratory Scale Aluminum Molten Salt Electrolysis

open access: yesAdvanced Engineering Materials, EarlyView.
A carbon‐free, as‐sintered MgO–steel cermet anode, fabricated via cold isostatic pressing using MgO–C refractory recyclate, was evaluated under laboratory‐scale K‐cryolite electrolysis at 800°C. Operation at this reduced temperature, combined with the electrolyte's limited electrical conductivity, led to an increase in cell voltage.
Farhan Hossain   +7 more
wiley   +1 more source

Mechanism and Simulation Analysis of Acoustic Wave Excitation by Partial Discharge

open access: yesApplied Sciences
Partial discharge serves as a typical indicator of insulation defects in high-voltage electrical equipment and is often accompanied by acoustic emission.
Ziqi Li   +4 more
doaj   +1 more source

Consumed by Abdominal Distention

open access: yes
Arthritis Care &Research, EarlyView.
Abimbola Fadairo‐Azinge   +3 more
wiley   +1 more source

Dielectric Barrier Discharge Plasma Deoxidation of Natively Oxide Layer of Copper Powders in a Fluidized Bed

open access: yesAdvanced Engineering Materials, EarlyView.
This paper presents a novel approach to reducing oxide layers on metal powders using low‐temperature hydrogen dielectric barrier discharge plasmas at atmospheric pressure. Unlike conventional hydrogen‐plasma reductions, the powders do not contact the plasma directly.
Shukang Zhang   +3 more
wiley   +1 more source

Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys

open access: yesAdvanced Engineering Materials, EarlyView.
Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak   +3 more
wiley   +1 more source

Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites

open access: yesAdvanced Engineering Materials, EarlyView.
Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter   +9 more
wiley   +1 more source

Home - About - Disclaimer - Privacy