Results 41 to 50 of about 15,464 (210)
Analysis and NN-based control of doubly fed induction generator in wind power generation [PDF]
, 2009 With the increasing size of wind power generation it is required to perform power system stability analysis that uses dynamic wind generator models.
Carvalho, Adriano +3 more
core +2 more sources
Primary frequency regulation strategy for doubly-fed induction generators based on virtual inertia
International Journal of Metrology and Quality EngineeringWith the continuous increase of wind power generation capacity, the necessity of wind power generation participating in primary frequency regulation is also increasing.
Zhao Jingwei, Dou Zhenhai
doaj +1 more source
Frontiers in Energy Research, 2023 With the proposal of carbon peaking and carbon neutralization, the penetration rate of wind power generation continues to increase. This paper focuses on the problem that doubly fed induction wind turbines are vulnerable to input “source” disturbances ...
Dongyang Sun +5 more
doaj +1 more source
Wind Power Generation, a Review of the Doubly Fed Induction Generator [PDF]
, 2015 In recent years, there’s been a renewed interest in renewable energy sources due to environmentalproblems and the eventual shortage of fossil fuels. Wind energy made considerable strides especially inEurope, particularly Denmark and Germany [1, 2].
Apata, O. O.
core
A simple maximum power point tracking based control strategy applied to a variable speed squirrel cage induction generator [PDF]
, 2012 This paper presents a comprehensive modelling and control study of a variable speed wind energy conversion system based on a squirrel-cage induction generator (SCIG).
Allali, A. +4 more
core +1 more source
Doubly Fed Induction Generator Subject to Symmetrical Voltage Sags
IEEE Transactions on Energy Conversion, 2011 The aim of this paper is to analyze the dynamic behavior of the doubly fed induction generator (DFIG) subject to symmetrical voltage sags caused by three-phase faults. A simple control algorithm is considered and assumed ideal: the rotor current irf in the synchronous reference frame is kept constant.
Rolán Blanco, Alejandro +2 more
openaire +3 more sources
Flux observer algorithms for direct torque control of brushless doubly-fed reluctance machines [PDF]
, 2009 Direct Torque Control (DTC) has been extensively researched and applied to most AC machines during the last two decades. Its first application to the Brushless Doubly-Fed Reluctance Machine (BDFRM), a promising cost-effective candidate for drive and ...
Chaal, Hamza, Jovanovic, Milutin
core +2 more sources
Investigation on the Modeling of Doubly-Fed Induction Generators for Wind Turbine
Algerian Journal of Signals and SystemsOver recent decades, especially in the transmission network, the share of electricity produced by wind sources has significantly increased. In order to enhance the efficiency of the power system, it is crucial to have precise and comprehensive ...
Yaakoub Diboune, Djilali Kouchih
doaj +1 more source
Jurnal Nasional Teknik Elektro, 2016 Wind turbine is one of the solutions to overcome the decreasing amount of fossil fuel. One type of generator which can be used on wind turbine application is Doubly Fed Induction Generator (DFIG).
Anisa Harumwidiah, Adi Kurniawan
doaj +1 more source
Embeddable parallel digital image of doubly-fed induction generator
Energy Reports, 2023 Due to the complexity of the structure of doubly-fed induction generator (DFIG), it is difficult to conduct real-time simulation. For this reason, this paper designs an embeddable parallel digital image IP of DFIG based on field programmable logic array (
Zheng Yang +5 more
doaj +1 more source