Results 161 to 170 of about 837,527 (297)

Effect of Drawing Speed on Infusion and Drawing Behavior of Poly(ethylene terephthalate) Filaments upon Cold Drawing

open access: yesEffect of Drawing Speed on Infusion and Drawing Behavior of Poly(ethylene terephthalate) Filaments upon Cold Drawing
identifier:oai:t2r2.star.titech.ac.jp ...
openaire  

Influence of an Oxygen‐Free Atmosphere on Diamond‐Single‐Grain Scratching of Ti–6Al–4V

open access: yesAdvanced Engineering Materials, EarlyView.
Single‐grain scratching of Ti–6Al–4V is investigated under controlled, oxygen‐free, and ambient atmospheres using a novel experimental setup with in situ high‐speed imaging. The approach enables direct observation of chip formation and adhesion under suppressed oxidation.
Berend Denkena   +2 more
wiley   +1 more source

Evaluating Energy Absorption Performance of Filled Lattice Structures

open access: yesAdvanced Engineering Materials, EarlyView.
Maximum stress must be considered to robustly evaluate energy absorber designs. This approach was applied to compare all types of absorbers in a single Ashby diagram and determine the utility of filling lattice voids with a second material. High‐performance fillers can improve the performance of lattices that are limited by buckling or catastrophic ...
Christian Bonney   +2 more
wiley   +1 more source

Dystonic tremor in Writer's cramp Mimicking primary handwriting tremor. [PDF]

open access: yesClin Park Relat Disord
Cataniag P   +3 more
europepmc   +1 more source

Dynamic Testing of Cold Gas Sprayed Bipolar Plates–Porous Transport Layer Coating System in Proton Exchange Membrane Water Electrolysis

open access: yesAdvanced Engineering Materials, EarlyView.
Through direct application of porous transport layer (PTL) on the bipolar plate (BPP) with thermal spraying, the interfacial contact resistance is improved. With the cold gas sprayed BPP–PTL coating system, a proton exchange membrane water electrolysis cell with a cell voltage of Ucell = 1.9 V can be operated up to i = 2.5 A/cm2 in a dynamic mode ...
Kirsten Bobzin   +5 more
wiley   +1 more source

Polymer additive manufacturing tools for sheet metal forming: a combined simulation and experimental study. [PDF]

open access: yesSci Rep
Bhatia CV   +7 more
europepmc   +1 more source

Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys

open access: yesAdvanced Engineering Materials, EarlyView.
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa   +9 more
wiley   +1 more source

Advancement and emerging challenges in electric-field assisted manufacturing: a review. [PDF]

open access: yesInt J Adv Manuf Technol
Kamal SM   +4 more
europepmc   +1 more source

Home - About - Disclaimer - Privacy