Results 1 to 10 of about 17,333 (260)
Examination of the Force Parameters in Drawing Process of CuZn39Pb3 Cast Rod using Selected Lubricants [PDF]
Archives of Foundry Engineering, 2023 The paper presents the results of research on the wire drawing process of wire brass using different deformation degree and using selected lubricants of different viscosity.
Michał Jabłoński
doaj +1 more source
Direct flow drawing equipment performance reliability and increase of its effectiveness [PDF]
E3S Web of Conferences, 2019 It is an analytic investigation of issues related to improving the efficiency and reliability of the drawing technological process, which are to be considered. After analytical efforts, a technical solution is proposed and justified.
Ivanova Veronica, Madrakhimov Daniyar
doaj +1 more source
Литьë и металлургия, 2019 The parameters of wire production affecting the distribution of residual stresses and strains on the wire cross section are considered. It is determined that the modes of coarse drawing can affect the complex of mechanical properties of thin wire due to ...
Yu. L. Bobarikin, Yu. V. Martyanov
doaj +1 more source
Archives of Metallurgy and Materials, 2017 The paper contains the theoretical and experimental analysis of the impact of the drawing angle on the drawing process and the properties of low carbon steel wires. A multi-stage drawing wire rod with a diameter of 5.5 mm on a wire with a diameter of 1.0
Suliga M., Wartacz R., Michalczyk J.
doaj +1 more source
In Situ Observation of Lubricant Film in a Diamond Die for Wire Drawing by Micro-FTIR
Tribology Online, 2016 The performance of wire drawing is closely dependent on lubrication between die and metal wire. The behavior of lubricants between the die and the wire plays an important role in the lubricating performance for wire drawing.
Yasushi Hoshi +4 more
doaj +1 more source
Литьë и металлургия, 2019 The possibility of application of the double finishing drawing die at the stage of fine-drawing in the manufacture of steel metal cord 2x0 30SHT is сontemplated.
V. A. Evdonich +3 more
doaj +1 more source
Fracture behavior of twinning-induced plasticity steel during wire drawing
Journal of Materials Research and Technology, 2020 The present study focuses on the effects of strain and temperature distribution on the fracture behavior in twinning-induced plasticity (TWIP) steel during wire drawing in order to understand the fracture mechanism of drawn TWIP steel wire.
Joong-Ki Hwang
doaj +1 more source
Enhancement of Copper Wire Lengthening Automatic System using Contactless Heater
International Journal of Networked and Distributed Computing (IJNDC), 2019 Copper wire can be elongated to a very thin size like 0.01 mm from an original 0.6 mm via wire drawing dies. Although automatic machines are available for wire elongating process, the wire threading through dies still requires a human operation before ...
Hsiung-Cheng Lin +2 more
doaj +1 more source
Finite Element Analysis on Ultrasonic Drawing Process of Fine Titanium Wire
Metals, 2020 Ultrasonic drawing is a new technology to reduce the cross-section of a metallic tube, wire or rod by pulling through vibrating dies. The addition of ultrasound is beneficial for reducing the drawing force and enhancing the surface finish of the drawn ...
Shen Liu +3 more
doaj +1 more source
Research of zinc coatings in thin medium carbon steel wires [PDF]
Archives of Metallurgy and Materials, 2019 An analysis of the effect of drawing speed on the formation of a zinc coating in the multi-stage fine steel wire drawing process has been carried out in the article. Pre-hardened 2.2 mm-diameter material was drawn into 1.00 mm-diameter wire in 6 draws on
M. Suliga, R. Wartacz, H. Kania
doaj +1 more source