Reliability-Based Design of Driven Piles Considering Setup Effects [PDF]
Applied Sciences, 2021 The total ultimate resistance (or bearing capacity) of driven piles considering setup effects is composed of initial ultimate resistance and setup resistance, and the setup effects of driven piles are mainly reflected by the setup resistance.
Xiaoya Bian +3 more
doaj +4 more sources
A Research for Deviation Estimation Analysis for Driven Piles Foundation: A Case of Penang Second Marine Bridge [PDF]
MATEC Web of Conferences, 2018 The aim of this preliminary research is to study the accept tolerance of driven piles with position’s deviation. More than five thousand driven piles were installed in the approach bridge, which adopted two classes, i.e.Φ1.6m steel pipe pile and Φ1.0m ...
Huang Kang
doaj +2 more sources
Bearing capability of driven piles with different types of cross-section [PDF]
Строительство уникальных зданий и сооружений, 2013 The research of influence of piles with cross section on the pile’s load capacity is published in this article. Special attention to driven piles was payed, because they are very popular in building area.
Georgiy Yakovlevich Bulatov +2 more
doaj +1 more source
Empirical Shaft Resistance of Driven Piles Penetrating Weak Rock [PDF]
Rock Mechanics and Rock Engineering, 2020 Luke J Prendergast
exaly +2 more sources
Reducing impact of embankment soils on shore support of bridge on the approaches to bridges [PDF]
E3S Web of Conferences, 2023 The article defines the reduction of active ground pressure and amplitude-frequency characteristics by theoretical and practical studies on approaches to bridges by driving reinforced concrete piles into the embankment.
Mekhmonov Mashkhurbek, Uralov Akmal
doaj +1 more source
Incorporating Setup Effects into the Reliability Analysis of Driven Piles
Applied Sciences, 2021 Driven-pile setup is referred to a phenomenon in which the bearing capacity of driven piles increases with time after the end of driving (EOD). The setup effect can significantly improve the bearing capacity (ultimate resistance) of driven piles after ...
Xiaoya Bian +3 more
doaj +1 more source
Prediction of bearing capacity of driven piles for Basrah governatore using SPT and MATLAB
Journal of the Mechanical Behavior of Materials, 2022 Based on the results of standard penetration tests (SPTs) conducted in Al-Basrah governorate, this research aims to present thematic maps and equations for estimating the bearing capacity of driven piles having several lengths. The work includes drilling
Karkush Mahdi O. +3 more
doaj +1 more source
Axial capacity ageing trends of large diameter tubular piles driven in sand
Soils and Foundations, 2023 The paper examines dynamic pile test data from 25 high-quality offshore cases, where end-of-initial driving (EoID) and beginning-of-restrike (BoR) instrumented dynamic monitoring was undertaken on tubular piles driven in sands at well-characterised sites
D. Cathie +4 more
doaj +1 more source
Behaviour of Single and Group Helical Piles in Sands from Model Experiments [PDF]
MATEC Web of Conferences, 2019 Mainly used foundations of oil sand plants are drilled shafts or driven piles. As environmental regulations become increasingly strict, complete removal of the foundation is becoming more important during the step of plant dismantling.
Bak Jongho +5 more
doaj +1 more source
Predicting Tensile Strength for Prestressed Reinforced Concrete-Driven Piles
Applied Sciences, 2022 Reinforced concrete piles installed by impact hammers have been used as a common solution for deep foundations because they are cost effective and require less time for construction.
Thuyet N. Nguyen +4 more
doaj +1 more source