Assessment of time effects on capacities of large-scale piles driven in dense sands
Canadian geotechnical journal (Print), 2023 This paper considers the axial resistances of open-ended, highly instrumented, 763 mm diameter steel pipe piles driven in sands for the EURIPIDES (EURopean Initiative on PIles in DEnse Sands) project at a well characterised research site at Eemshaven, in
K. Wen +9 more
semanticscholar +1 more source
Development of a Unified Geotechnical Database and Data Processing on the Example of Nur-Sultan City
Applied Sciences, 2020 Development of a geotechnical database for the young capital of Kazakhstan, Nur-Sultan city, became a paramount concern of both the scientific community and industry.
Askar Zhussupbekov +3 more
doaj +1 more source
A Numerical Analysis on Pullout Capacity of Batter Pile Groups in Sandy Soil [PDF]
Engineering and Technology Journal, 2022 Batter piles or raker piles are the piles driven in the soil at an inclination with the vertical to resist inclined forces or large lateral loads.
Mais Al-Tememy +2 more
doaj +1 more source
Set-up effects of piles in sand tested in the centrifuge [PDF]
, 2014 The bearing capacity of piles increases over time. Research has shown that this is caused by an increase in shaft friction combined with a constant or only slightly increasing base capacity.
Bezuijen, Adam +4 more
core +2 more sources
Organisational and technological reliability of pile foundation construction flow in permafrost [PDF]
E3S Web of ConferencesThe construction of pile foundations in permafrost conditions is a durable and cost-effective design that shows high performance of piles in contrast to slab, block and strip foundations. In the Russian experience of construction in permafrost conditions,
Stoyanov Igor
doaj +1 more source
Considerations for Measuring Residual Stresses in Driven Piles with Vibrating Wire Strain Gauges
, 2021 Vibrating wire strain gauges are often the preferred technology for measuring strain in driven piles.
J. Bartz, J. Blatz
semanticscholar +1 more source
Cone penetration test-based load-transfer formulations for driven piles in sand
, 2020 This paper presents the development of load transfer curves that can be used to estimate the displacement under axial load of driven piles in sand.
Barry Lehane, Liang Li, Eduardo Bittar
openalex +2 more sources
Reducing driving forces for pressed-in piles [PDF]
, 2012 Pile jacking techniques use static loading to install sheet piles with minimal environmental effects, such as noise and ground vibrations, which are often associated with other methods of driven piling.
Andrew Martin McNamara +6 more
core +1 more source
Evolution of pile shaft capacity over time in marine soils
International Journal of Geo-Engineering, 2017 Driven pile foundations may experience an increase in bearing capacity overtime after installation which is referred to as pile set-up or freeze. Field observations have demonstrated that pile set-up could be substantial and the evolution of pile shaft ...
Mohammad Amin Hosseini, Mohammad Rayhani
doaj +1 more source
Casting and installation of segmental precast quadratic concrete driven geothermal energy piles
Symposium on Energy Geotechnics 2023, 2023 Geothermal energy pile foundations are used both for structural purposes and to provide sustainable, clean, and cost-effective ground energy for heating and cooling buildings [1].
Habibollah Sadeghi, Rao Martand Singh
semanticscholar +1 more source