Results 71 to 80 of about 62,214 (183)
ABSTRACT In this study, bioassay‐guided fractionation of the ethanolic extract from Eremanthus crotonoides leaves enabled the isolation of two bioactive sesquiterpene lactones, centratherin and goyazensolide, which were evaluated for their antimycobacterial and anti‐inflammatory properties.
Natalie Giovanna da Rocha Ximenes +7 more
wiley +1 more source
This paper describes the isolation and antifungal activity of secondary metabolites from the leaves and roots of Monotes kerstingii. The distribution of these metabolites in the roots and leaves was achieved through comprehensive RP‐UHPLC‐Orbitrap‐MS and MS/MS analysis.
Sorelle Kache Fotsing +12 more
wiley +1 more source
Physics‐Guided Transfer Learning for Predicting Stress–Strain Curves With Limited Experimental Data
ABSTRACT Many measurements in materials science are expressed as full response curves rather than single scalar values. Nevertheless, predicting entire curves reliably from limited experimental data remains challenging. Here, we address this problem for hot‐deformation stress–strain curves using a physics‐guided transfer learning (PGTL) framework that ...
Jiaxuan Ma +4 more
wiley +1 more source
Hot workability, microstructural evolution, and dual path DRX mechanism of the 70Cu–30Ni alloy
This work systematically investigates the hot deformation behavior of the 70Cu–30Ni alloy for marine engineering through hot compression tests. The microstructural evolution and dynamic recrystallization (DRX) mechanisms were thoroughly analyzed via ...
Qiuhua Guo +6 more
doaj +1 more source
Effect of Dynamic Recrystallization on the Transformed Ferrite Microstructures in HSLA Steel
The flow stress behavior of high-strength low-alloy (HSLA) steel at different true strains was studied using a hot compression test. The effect of dynamic recrystallization (DRX) on the transformed ferrite microstructures was investigated with electron ...
Ning Li +5 more
doaj +1 more source
Controlling the evolution process of columnar grains is benefits to achieve microstructure regulation during subsequent hot processing in superalloys.
Hao Yu +5 more
doaj +1 more source
A review on kinetic models of dynamic recrystallization for magnesium alloys
Mg alloys are the lightest metallic structural material with tremendous application value. Dynamic recrystallization (DRX) is the most important grain refining and texture weakening mechanism for Mg alloys.
Tong Wang +5 more
doaj +1 more source
Se estudia la composición por difracción de rayos X y QEMSCAN (19 muestras) de fangolitas y margas de la Formación Vaca Muerta, acumuladas durante la transgresión tithoniana de la Cuenca Neuquina.
Luis Spalletti +7 more
doaj
Hot deformation with high strain rate has been paid more attention due to its high efficiency and low cost, however, the strain rate dependent dynamic recrystallization (DRX) and texture evolution in hot deformation process, which affect the formability ...
Ning Ding +5 more
doaj +1 more source
En este trabajo, se presentan los resultados preliminares de peliculas nanoestructuradas de nitruro de aluminio (AlN), que fueron depositadas con el metodo de deposicion por laser pulsado (PLD).
Jaime Andrés Pérez Taborda +3 more
doaj

