Results 21 to 30 of about 1,045,728 (294)

Carbon Dioxide Reforming of Tar During Biomass Gasification

Chemical Engineering Transactions, 2014
The energy demand increase and the necessity to contain CO2 emissions lead to a growing interest on renewable and CO2 free energy sources. Gasification has been identified as a key technology to enhancethe environmental tolerability of low quality fuels
B. De Caprariis, C. Bassano, P. Deiana, V. Palma, A. Petrullo, M. Scarsella, P. De Filippis   +6 more
doaj   +1 more source

Energy Analysis in Combined Reforming of Propane

Journal of Engineering, 2013
Combined (steam and CO2) reforming is one of the methods to produce syngas for different applications. An energy requirement analysis of steam reforming to dry reforming with intermediate steps of steam reduction and equivalent CO2 addition to the feed ...
K. Moon, Ganesh R. Kale
doaj   +1 more source

CO₂ valorization: Production of Synthetic Gasoline and Diesel Fuel from Dry Reforming of Methane

Chemical Engineering Transactions, 2012
The purpose of this study is to illustrate the potential of dry reforming of methane for industrial applications by producing synthetic fuels from the combination of dry and steam reforming of methane.
H. Er-rbib, C. Bouallou, F. Werkoff
doaj   +1 more source

Life cycle environmental performance of methanol production through photocatalytic dry methane reforming

Journal of CO2 Utilization
Photocatalytic dry methane reforming uses light energy and a nanostructured photocatalyst to convert both carbon dioxide and methane gas to syngas for production of fuels and value-added chemicals. The conversion of these two greenhouse gases (GHG) makes
B. Robbins, A. Gaona, A. Tavasoli, J.A. Bergerson, B.A. Saville, H.L. MacLean   +5 more
doaj   +1 more source

Thermodynamic analysis of glycerol dry reforming [PDF]

, 2013
The growing demand for hydrogen energy requires renewable raw materials for its production. In particular, production of alternatives fuels such as biodiesel and ethanol has increased over the last few years culminating in increased glycerol output, a ...
Latifah Sakinah, Ismail
core   +2 more sources

Experimental system for dry reforming of methane.

, 2016
Experimental system for dry reforming of methane.
Zaidi Embong (844542), Yun Hin Taufiq-Yap (839565), Zulkarnain Zainal (844540), Aminul Islam (446588), Mohd Izham Saiman (844541), Faris A. J. Al-Doghachi (844539)   +5 more
core   +1 more source

Mathematical Modelling of Catalytic Fixed-Bed Reactor for Carbon Dioxide Reforming of Methane over Rh/Al2O3 Catalyst [PDF]

, 2008
A one-dimensional mathematical model was developed to simulate the performance of catalytic fixed bed reactor for carbon dioxide reforming of methane over Rh/Al2O3 catalyst at atmospheric pressure.
Istadi, I., Saidina Amin, N.A., Yee, N.P.   +2 more
core   +2 more sources

Process Simulation for Solar Steam and Dry Reforming

Energy Procedia, 2014
AbstractIn co-operation with the German Aerospace Center, the Solar-Institut Jülich has been analyzing the different technologies that are available for methanol production from CO2 using solar energy. The aim of the project is to extract CO2 from industrial exhaust gases or directly from the atmosphere to recycle it by use of solar energy. Part of the
Kluczka, Sven (M.Sc.), Eckstein, Julian, Alexopoulos, Spiros (Prof. Dr.-Ing.), Vaeßen, Christiane (Prof. Dr. rer. nat.), Roeb, Martin   +4 more
openaire   +2 more sources

Fabrication Routes for Ionic Conducting Fiber Strain Sensors

Advanced Engineering Materials, EarlyView.
Ionic conducting fiber strain sensors (ICFSs) offer compliant, textile‐integrable sensing. Thus far, the commercialization of ICFSs has been constrained by fiber fabrication routes. This review provides a fabrication‐centric analysis of ICFSs correlating processing strategies with material properties and scalability.
Leo John Kershaw, Zhanhong Yang, Anne Ladegaard Skov, Magdalena Skowyra   +3 more
wiley   +1 more source

Assessment of process conditions in the dry reforming of HDPE fast pyrolysis volatiles for syngas production

Journal of CO2 Utilization
The joint valorization of CO2 and high density polyethylene (HDPE) has been carried out by means of a two-stage process consisting of plastic fast pyrolysis and in-line dry reforming.
Leire Olazar, Laura Santamaria, Martin Olazar, Maider Amutio, Gartzen Lopez, Maite Artetxe   +5 more
doaj   +1 more source