A Review of Different Configurations and Control Techniques for DSTATCOM in the Distribution system [PDF]
E3S Web of Conferences, 2021 This paper presents a review of DSTATCOM Topologies and power quality control Techniques. The used topologies are Three-phase Three-wire and Three-phase four-wire and control techniques are Instantaneous reactive power theory(IRP), Synchronous Reference ...
Sree Jyothi Khammampati R +2 more
doaj +2 more sources
Modified Proportionate Affine Projection Algorithm Based Adaptive DSTATCOM Control With Increased Convergence Speed [PDF]
IEEE Access, 2022 The three-phase DSTATCOM is prone to higher dynamics due to grid disturbances. The proportionate affine projection algorithm (PAPA) is an adaptive filter that can be used for DSTATCOM control.
Arobinda Dash +5 more
doaj +2 more sources
Power Quality Enhancement Using Power Balance Theory Based DSTATCOM [PDF]
Advances in Electrical and Electronic Engineering, 2016 The DSTATCOM (Distributed Static Compensator) is used for current harmonic mitigation, Power Factor Correction (PFC), reactive power compensation, load balancing and neutral current compensation in the Power Distribution System (PDS).
Jampana Bangarraju +2 more
doaj +7 more sources
ANFIS Based Reduce Device Count DSTATCOM
Journal of Applied Science and Engineering, 2023 In this article reduced switch count-based distributed static compensator (DSTATCOM) is presented. DSTATCOM is a reduced switch count-based multilevel inverter (MLI)-based DSTATCOM that is used to eliminate harmonics in the source current caused by a non-
Kalagotla Chenchireddy, V Jegathesan
doaj +2 more sources
Real-time assessment of PV-DSTATCOM for grid power quality enhancement using an indirect current control strategy [PDF]
Scientific ReportsThis paper presents a real-time simulation of a photovoltaic-based distribution static compensator (PV-DSTATCOM) using the Typhoon HIL 604 simulator, demonstrating its effectiveness in reactive power compensation, harmonic mitigation, and active power ...
Vinamra Kumar Govil +2 more
doaj +2 more sources
DSTATCOM allocation in distribution networks considering load variations using bat algorithm
Ain Shams Engineering Journal, 2017 This paper proposes a new method of scheduling for optimal placement and sizing of Distribution STATic COMpensator in the radial distribution networks to minimize the power loss.
T. Yuvaraj, K. Ravi, K.R. Devabalaji
doaj +2 more sources
Alexandria Engineering Journal, 2022 Due to the non-linear nature of most of the loads, there is a greater demand for reactive power in the distribution network. Further, it wasted high energy on distribution and dropped the bus voltages.
Baseem Khan +5 more
doaj +2 more sources
Evaluation of SVC-Coupled Hybrid DSTATCOM using JLMS Algorithm for Enhancement of Power Quality
Power Electronics and Drives, 2023 This research study explains the design and performance of a Static VAR Compensator (SVC) coupled Hybrid Distribution Static Compensator (DSTATCOM) for low voltage power distribution system (PDS).
Mangaraj Mrutyunjaya, Sabat Jogeswara
doaj +1 more source
VSC-Based DSTATCOM for PQ Improvement: A Deep-Learning Approach
Power Electronics and Drives, 2022 With the rapid advancement of the technology, deep learning supported voltage source converter (VSC)-based distributed static compensator (DSTATCOM) for power quality (PQ) improvement has attracted significant interest due to its high accuracy.
Mangaraj Mrutyunjaya +4 more
doaj +1 more source
An efficient compensation of modified DSTATCOM for improving microgrid operation
Alexandria Engineering Journal, 2022 This paper proposes a design for a modified distribution static compensator (DSTATCOM) with a proposed current controller for microgrid (MG) applications.
Abdelazeem A. Abdelsalam +2 more
doaj +1 more source