Results 71 to 80 of about 59,410 (311)
Time‐Dependent Oxidation and Scale Evolution of a Wrought Co/Ni‐Based Superalloy
Advanced Engineering Materials, EarlyView.This study shows how a new wrought Co/Ni‐based superalloy resists oxidation at 800 ∘$^\circ$C. The oxide scale changes from rough, fast‐growing spinel to a dense, protective chromia–alumina layer. Atom probe analysis reveals tiny refractory‐rich bubbles at the interface that mark the transition to long‐term, diffusion‐controlled protection ...
Cameron Crabb +6 more
wiley +1 more source
A Novel Dual-Broadband Circularly Polarized Patch Antenna for Precise Satellite Navigation
International Journal of Antennas and Propagation, 2019 This paper presents a novel dual-band circularly polarized patch antenna for precise satellite navigation. The radiation elements are composed of the inner cross-shaped patch and the outer annular patch which are printed on the same surface of one ...
Fumin Lin +5 more
doaj +1 more source
, 2013 This paper presents a simplified approach to the design of a single feed dual polarised, dual frequency (1.9 and 2.4 GHz) aperture coupled microstrip antenna. Using simulation and practical investigation, the coupling between the microstrip feed line and
Ghassemlooy, Zabih +7 more
core +1 more source
Karl Popper and the Mechanisms of Hydrogen Embrittlement
Advanced Engineering Materials, EarlyView.Representation of the beginning of loss of ductility rather than embrittlement. Small concentrations of hydrogen in a diffusible form within iron are well‐established to harm the mechanical integrity of steels. There are theories that attempt to explain the pernicious role of hydrogen.
H. K. D. H. Bhadeshia
wiley +1 more source
, 2009 A design strategy using Photonic Band Gap (PBG) structure on ground plane to achieve wider bandwidth for patch antenna is presented. It is found that, the impedance bandwidth has improved from 3.72% to 31.9% at centre frequency 9 GHz after adding PBG on ...
AbuTarboush, HF +5 more
core +1 more source
Multiband low-profile antenna for remote antenna unit picocell applications [PDF]
, 2008 The design of a compact, low-profile antenna constructed from five wire-patch elements is investigated. For a fiber-radio system a critical design parameter is the isolation between two WLAN elements.
Callaghan, Peter, Batchelor, John C.
core +1 more source
Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A
Advanced Engineering Materials, EarlyView.The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han +5 more
wiley +1 more source
Analysis and Design of a Dual Band-Notched UWB Antenna Using Complementary Split Ring Resonator
Journal of Communications Software and Systems, 2018 In this paper, the complementary split ring resonator (CSRR) is studied and applied to design a printed ultra wideband (UWB) antenna with dual band-notched characteristics. Dual band-notched function is obtained by incorporating the CSRR in the radiating
Abdelghani Nacer +1 more
doaj
A Dual-band Microstrip Slotted Antenna for UHF and Microwave RFID Readers
, 2018 In this paper a new and simple dual-band microstrip slot antenna design combined with two inverted L-shaped slots integrated in the radiating patch is presented.
Zbitou, Jamal; Hassan 1st University +5 more
core +1 more source
Advanced Engineering Materials, EarlyView.Graphene nanoplatelet (0.1 wt.%) reinforcement significantly enhances the performance of β Ti‐28Nb‐35.4Zr alloy. Grain refinement, reduced water contact angle, and improved surface characteristics promote osteoblast adhesion and complete surface coverage after 7 days.
Khurram Munir +5 more
wiley +1 more source