Reactive power minimization of dual active bridge DC/DC converter with triple phase shift control using neural network [PDF]
, 2014 Reactive power flow increases dual active bridge (DAB) converter RMS current leading to an increase in conduction losses especially in high power applications.
Aboushady, Ahmed +2 more
core +2 more sources
Generalized small-signal modelling of dual active bridge DC/DC converter [PDF]
, 2018 this paper presents a novel generalised approach of the small-signal modelling of dual active bridge (DAB) DC/DC converter. The adopted analysis is based on a per-unit fundamental frequency representation of the DAB. The outcome of the proposed modelling
Aboushady, Ahmed A. +4 more
core +3 more sources
DC fault isolation study of bidirectional dual active bridge DC/DC converter for DC transmission grid application [PDF]
, 2015 Fast isolation and detection of DC faults is currently a limiting factor in high power DC transmission grid development. Recent research has shown that the role of DC/DC converters is becoming increasingly important in solving various DC grid challenges ...
Aboushady, Ahmed A. +2 more
core +2 more sources
Application of Thermal Balance Phase-Shift Control Strategy to Dual-Active-Bridge DC-DC Converter [PDF]
Xibei Gongye Daxue Xuebao, 2018 With the development of the more/All electrical aircraft technology, the dual active bridge converter has been applied to the energy storage device to realize the bidirectional power flow in aircraft electrical system.
doaj +1 more source
Comprehensive steady state analysis of bidirectional dual active bridge DC/DC converter using triple phase shift control [PDF]
, 2014 Several papers have been published recently on TPS control of dual active bridge (DAB) converter, however, no complete study of the converter operation behaviour exists, that takes into account all switching modes in both charging and discharging ...
Aboushady, A.A. +3 more
core +3 more sources
Analysis and design of a modular multilevel converter with trapezoidal modulation for medium and high voltage DC-DC transformers [PDF]
, 2015 Conventional dual active bridge topologies provide galvanic isolation and soft-switching over a reasonable operating range without dedicated resonant circuits.
Adam, Grain P. +4 more
core +5 more sources
Modular dual active bridge converter architecture [PDF]
, 2016 This paper describes a modular1 architecture based on the Dual Active Bridge (DAB) converter in input series, output parallel (ISOP) connection. The work is focused on the input voltage sharing to ensure a proper operation of each module by means of an ...
Barrado Bautista, Andrés +6 more
core +2 more sources
Generic closed loop controller for power regulation in dual active bridge DC-DC converter with current stress minimization [PDF]
, 2018 This paper presents a comprehensive and generalized analysis of the bidirectional dual active bridge (DAB) DC/DC converter using triple phase shift (TPS) control to enable closed loop power regulation while minimizing current stress.
Abdelsalam, Ibrahim +3 more
core +3 more sources
A Bidirectional Soft-Switched DAB-Based Single-Stage Three-Phase AC–DC Converter for V2G Application [PDF]
, 2019 In vehicle-to-grid applications, the battery charger of the electric vehicle (EV) needs to have a bidirectional power flow capability. Galvanic isolation is necessary for safety.
Baranwal, Rohit +4 more
core +2 more sources
Applied Sciences, 2023 The LCL-type dual active bridge (LCL-DAB) DC-DC converter is a promising part for DC micro-grids due to its high voltage gain and low bridge current, but the issues of backflow power elimination and transient response optimization deserve attention in ...
Mingxue Li +6 more
doaj +1 more source