Modular dual active bridge converter architecture [PDF]
, 2016 This paper describes a modular1 architecture based on the Dual Active Bridge (DAB) converter in input series, output parallel (ISOP) connection. The work is focused on the input voltage sharing to ensure a proper operation of each module by means of an ...
Barrado Bautista, Andrés +6 more
core +2 more sources
Analysis and design of a modular multilevel converter with trapezoidal modulation for medium and high voltage DC-DC transformers [PDF]
, 2015 Conventional dual active bridge topologies provide galvanic isolation and soft-switching over a reasonable operating range without dedicated resonant circuits.
Adam, Grain P. +4 more
core +5 more sources
Generic closed loop controller for power regulation in dual active bridge DC-DC converter with current stress minimization [PDF]
, 2018 This paper presents a comprehensive and generalized analysis of the bidirectional dual active bridge (DAB) DC/DC converter using triple phase shift (TPS) control to enable closed loop power regulation while minimizing current stress.
Abdelsalam, Ibrahim +3 more
core +3 more sources
Applied Sciences, 2023 The LCL-type dual active bridge (LCL-DAB) DC-DC converter is a promising part for DC micro-grids due to its high voltage gain and low bridge current, but the issues of backflow power elimination and transient response optimization deserve attention in ...
Mingxue Li +6 more
doaj +1 more source
Analysis of AC link topologies in non-isolated DC/DC triple active bridge converter for current stress minimization [PDF]
, 2017 This paper presents analysis of the non-isolated DC/DC triple active bridge (TAB) converter under various purely inductor-based AC link topologies. The objective of the analysis is to find the topology that incorporates the least value of the AC link ...
Aboushady, Ahmed A. +2 more
core +3 more sources
A Bidirectional Soft-Switched DAB-Based Single-Stage Three-Phase AC–DC Converter for V2G Application [PDF]
, 2019 In vehicle-to-grid applications, the battery charger of the electric vehicle (EV) needs to have a bidirectional power flow capability. Galvanic isolation is necessary for safety.
Baranwal, Rohit +4 more
core +2 more sources
IEEE Access, 2021 The cooperative triple-phase-shifted modulation (CTPS) for the isolated dual-active bridge (DAB) DC-DC converter has the advantages of zero dual-DC side flow back currents and best current characteristics.
Yong Dai, Suhua Luo, Zhongwei Li
doaj +1 more source
Operating Principle and Performance Optimization of a Three-Level NPC Dual-Active-Bridge DC-DC Converter [PDF]
, 2015 © 1982-2012 IEEE. Aiming to improve the performance features of conventional two-level dual-active-bridge (DAB) converters, this paper presents a three-level neutral-point-clamped (NPC) DAB dc-dc converter.
Bordonau Farrerons, José +3 more
core +2 more sources
Device loss model of a fully SiC based dual active bridge considering the effect of synchronous rectification and deadtime [PDF]
, 2018 It is becoming a great interest to employ SiC based power devices in dual active bridge (DAB) converter as an alternative to conventional Si-IGBT, due to its higher switching frequency potential, smaller switching losses as well as the capability to ...
Castellazzi, Alberto, Wang, Zhenyu
core +1 more source
Mathematics, 2022 This paper proposes a two-degree-of-freedom (2-DoF) modulation technique for the efficient optimization of an open-loop three-phase dual-active-bridge series resonant converter (3P-DABSRC).
Asad Hameed +6 more
doaj +1 more source