Results 251 to 260 of about 28,532,237 (300)

Tailoring Antiplatelet Adherence: An EHR-Enabled Model for P2Y<sub>12</sub> Inhibitor Therapy Among Veterans. [PDF]

open access: yesJACC Case Rep
Singh RP   +5 more
europepmc   +1 more source
Some of the next articles are maybe not open access.

An analysis of band gap characteristics of metamaterial plates with dual helix cells

Mechanics of Advanced Materials and Structures, 2023
Wide band gaps with the propagation of elastic waves at low-frequency are desirable for phononic crystals in many traditional and novel applications. Inspired by the natural helix, we designed a microstructure in a metamaterial plate with an antisymmetric dual helix as the basic local resonant cell.
Yumei Chen   +4 more
openaire   +1 more source

Analysis of Waveguide Post Configurations: Part II--Dual-Gap Cases

IEEE Transactions on Microwave Theory and Techniques, 1977
The analysis given in Part I is applied to two particular structures of general interest. The first is the two-post case, each post having one gap, and the second is the single-post with two gaps. The impedance or admittance matrix elements are used to construct the gap port networks which are then used to obtain the waveguide obstacle representations.
J.S. Joshi, J.A.F. Cornick
openaire   +1 more source

Quantitative analysis of dual whole-cell voltage-clamp determination of gap junctional conductance

Pfl�gers Archiv European Journal of Physiology, 1998
The dual whole-cell voltage-clamp technique is used widely for determination of kinetics and conductance of gap junctions. The use of this technique may, however, occasion to considerable errors. We have analysed the errors in steady state junctional conductance measurements under different experimental conditions.
van Rijen, H. V.   +3 more
openaire   +4 more sources

Characteristics of dual reflector antennas with gaps placed on the subreflector: MoM and PO analysis

IEEE Antennas and Propagation Society International Symposium. 1999 Digest. Held in conjunction with: USNC/URSI National Radio Science Meeting (Cat. No.99CH37010), 2003
In some applications construction of reflector antennas require assembling smaller panels and conforming them to reflector surfaces, a process, which naturally leave gaps between the panels. Consequently, characterization of performance from these gaps, though small in terms of wavelength, becomes an important issue in antenna analysis and design.
B. Khayatian, Y. Rahmat-Samii
openaire   +1 more source

Home - About - Disclaimer - Privacy