Results 31 to 40 of about 49,081 (299)
An Athermal Brittle to Ductile Transition in Amorphous Solids
Brittle materials exhibit sharp dynamical fractures when meeting Griffith's criterion, whereas ductile materials blunt a sharp crack by plastic responses.
Dauchot, Olivier +3 more
core +3 more sources
The overarching goal of this research was to investigate the application of spherically shaped abrasive particles in achieving ductile-mode cutting. Scratching experiments were carried out to assess the differences between arbitrarily and spherically ...
Andrii M. Kovalchenko +4 more
doaj +1 more source
We perform a large-scale statistical analysis (> 2000 independent simulations) of the elongation and rupture of gold nanowires, probing the validity and scope of the recently proposed ductile-to-brittle transition that occurs with increasing nanowire ...
Cummings, Peter T. +4 more
core +1 more source
Deformation mechanisms in nanotwinned metal nanopillars [PDF]
Nanotwinned metals are attractive in many applications because they simultaneously demonstrate high strength and high ductility, characteristics that are usually thought to be mutually exclusive.
Gao, Huajian +3 more
core +1 more source
After a gas drainage event causes different degrees of initial porosity in the coal seam, the heterogeneity of the coal mass becomes much more obvious. In this paper, soft coal testing samples with different degrees of heterogeneity were prepared first ...
Weijian Yu +3 more
doaj +1 more source
Brittle-to-ductile transition of PLA induced by macromolecular orientation
This work deals with the influence of biaxial orientation on the mechanical behavior of Polylactide (PLA) films. Comparisons between a crystallizable grade and a non-crystallizable one have been made in order to separate the effect of macromolecular ...
S. Xu +4 more
doaj +1 more source
Discrete Element Analysis of Ice-Induced Vibrations of Offshore Wind Turbines in Level Ice
Self-excited vibrations of offshore structures interacting with sea ice, characterized by low frequency and high amplitudes, pose significant hazards to offshore wind turbines (OWTs) in cold seas. This study employs the discrete element method (DEM) with
Xue Long, Lu Liu, Shunying Ji
doaj +1 more source
Analytical modeling of surface roughness in precision grinding of particle reinforced metal matrix composites considering nanomechanical response of material [PDF]
Grinding is usually applied for particle reinforced metal matrix composites (PRMMCs) to achieve high ground surface quality. However, the surface quality especially surface roughness is difficult to predict theoretically due to different mechanical ...
Cai, Rui +5 more
core +1 more source
Ductile-to-brittle transition in aluminum alloys
Here we exploited room (298 K) – and cryogenic (77 K) – temperature mechanical behaviors of binary Al-Mg alloys across a wide range of magnesium concentration (i.e. 2.8–13.1 at.%). We observed ductile-to-brittle transition at 77 K as Mg content increases
Dengshan Zhou +11 more
doaj +1 more source
In-situ experiment on critical thickness of brittle-ductile transition of single-crystal silicon
Single-crystal silicon is widely used in optoelectronics and micro-electromechanical systems because of its unique physical and chemical properties.
LIU Bing +3 more
doaj +1 more source

