Results 51 to 60 of about 4,302 (163)

Improvement of Stockbridge Damper Design for Cable-Stayed Bridges

open access: yesApplied Mechanics
Stockbridge dampers are widely used to mitigate the vibrations of cable-stayed bridges and of many other cable-suspended or cable structures exposed to the action of pedestrians, traffic or wind load.
Adél Olosz   +3 more
doaj   +1 more source

Development of the Viscous Plane Damper Applicable in Limited Space within Structures Subjected to Dynamic Loads

open access: yesApplied Sciences
Shipping impact and wave loads impose dynamic loads on jetties and platforms in the sea, which cause the vibration of structures. Recently, many advanced viscous damper devices have been developed for implementation in structures to diminish structural ...
Mohd Ridzuan Bin Mohd Ali, Farzad Hejazi
doaj   +1 more source

DYNAMIC MODEL OF HIGH-FREQUENCY VIBRATION DAMPERS FOR POWER LINE CONDUCTORS

open access: yesInternational Journal for Computational Civil and Structural Engineering
A dynamic model of an aeolian vibration damper for overhead power transmission line conductors has been developed, taking into account energy dissipation in the material structure.
Alexander Danilin   +3 more
doaj   +1 more source

Influence of Oil Temperature of Yaw Damper on Dynamic Performance

open access: yes机车电传动, 2016
Detriment of increasing of oil temperature was analyzed, and then a different temperature test on yaw damper of a highspeed vehicles was performed. Based above, a new-type yaw damper with temperature compensation was proposed. It could be concluded that:
XU Tengyang   +5 more
doaj  

Structure-borne transmissibility evaluation through modeling and analysis of aircraft vibration dampers [PDF]

open access: yesJournal of Aerospace Technology and Management, 2011
In the aircraft industry a great practical relevance is given to the extensive use of vibration dampers between fuselage and interior panels. The proper representation of these isolators in computer models is of vital importance for the accurate ...
Isabel Lima Hidalgo   +2 more
doaj  

The Effects of Dynamic Loading on Hysteretic Behavior of Frictional Dampers

open access: yesShock and Vibration, 2014
During an earthquake excitation, a frictional damper may experience many cycles of dynamic loading. The effects of wear and heat induced by the cyclic loading result in the possible decay of the slippage load which subsequently reduce the energy ...
Hamid Rahmani Samani   +3 more
doaj   +1 more source

Electromagnetic damper using brushless direct drive DC motor

open access: yesMechanical Engineering Journal, 2018
To fabricate a semiactive type of damper that is comparatively compact and has low mechanical loss, the author developed an electromagnetic damper using a brushless direct drive DC motor. The damper comprises a ball screw mechanism and a brushless direct
Taichi MATSUOKA
doaj   +1 more source

Analyse of effective for dynamic response reduction of combining damper consisting of Viscous Fluid Damper, Magneto-Rheological Damper – Connected coupled structures

open access: yesTạp chí Khoa học Đại học Mở Thành phố Hồ Chí Minh - Kỹ thuật và Công nghệ, 2013
This paper studies dynamic reduction of combining damper consisting of Viscous Fluid Damper, VFD, which set inside individual structure and Magneto Rheological Damper, MRD, which set between two structures under ground motion.
Lê Thanh Cường   +1 more
doaj  

STUDY ON THE ACTIVE VIBRATION SUPPRESSION METHOD OF HYDROSTATIC SLIDE OF MACHINE TOOL BASED ON MR DAMPER

open access: yesJixie qiangdu, 2022
The dynamic behaviors of the hydrostatic slide is changed instantaneously and abruptly during the start-stop, acceleration and deceleration, so magnetorheological(MR) damper is used to suppress tangential vibration of hydrostatic slide.
ZHANG ZhongKui   +3 more
doaj  

Design of a frictionless magnetorheological damper with a high dynamic force range

open access: yesAdvances in Mechanical Engineering, 2019
This article discusses an increase in dynamic force range in a spring–damper unit achieved by elimination of sealings’ friction. This friction is a part of damping force that cannot be controlled; therefore, it is undesirable in magnetorheological ...
Ondřej Macháček   +4 more
doaj   +1 more source

Home - About - Disclaimer - Privacy