Results 31 to 40 of about 2,292,684 (349)
SAW torque transducers for disturbance rejection and tracking control of multi-inertia servo-drive systems [PDF]
, 2004 The paper proposes a resonance ratio control (RRC) technique for the coordinated motion control of multi-inertia mechanical systems, based on the measurement of shaft torque via a SAW-based torque sensor. Furthermore, a new controller structure, RRC plus
Bingham, C M +2 more
core +1 more source
Testing the superblock deck by dynamic loads
IOP Conference Series: Materials Science and Engineering, 2020 AbstractTyumen oil and gas industry province is being developed with the use of complete block construction. Especially increases the importance of building large blocks with installed equipment and superblocks on a floating mobile base. Styrofoam concrete is used to insulate the superblock deck.
Lyudmila Stefurak, Peter Stefurak
openaire +1 more source
Frontiers in Built Environment, 2020 In this article, dynamic and static load tests of a concrete highway bridge, which is a deteriorated and repaired, are presented depending on displacement and strain data for engineering decision making about the operation of a critical bridge.
C. Dong +6 more
semanticscholar +1 more source
Dynamic crack mechanism model place in the designing of the buildings [PDF]
MATEC Web of Conferences, 2021 The materials that we use always have some defects. Under static, cycling or dynamic load the materials as a function of the crack size and load environment can initiate a fracture. The crack mechanism depends on several factors, like material properties,
Nyikes Zoltán, Kovács Tünde Anna
doaj +1 more source
Measurements of SCRF cavity dynamic heat load in horizontal test system
, 2010 The Horizontal Test System (HTS) at Fermilab is currently testing fully assembled, dressed superconducting radio frequency (SCRF) cavities. These cavities are cooled in a bath of superfluid helium at 1.8K.
Bossert, R. J. +3 more
core +1 more source
DYNAMIC TESTING OF BRIDGES WITH IMPULSE LOADING
Dorogi i mosti, 2023 Introduction. This article deals with the practice of applying the method of dynamic testing of bridges, namely, modal control using impulse loading. The possibilities of this method for determining the technical condition of a bridge span structure by determining its natural characteristics: actual stiffness and parameters of natural vibration forms ...
Serhii Zavhorodniy, Vasyl Redchenko
openaire +1 more source
Dynamic Load Altering Attacks Against Power System Stability: Attack Models and Protection Schemes
IEEE Transactions on Smart Grid, 2017 Dynamic load altering attacks (D-LAAs) are introduced as a new class of cyber-physical attacks against smart grid demand response programs. The fundamental characteristics of D-LAAs are explained.
Sajjad Amini +2 more
semanticscholar +1 more source
Coupled Vibration Analysis of Multi-Span Continuous Cable Structure Considering Frictional Slip
Applied SciencesAs important load-bearing structures, suspension cables have been widely used in suspension bridges, engineering ropeways, cable suspension systems and other special equipment. Their dynamic problems have always been a research hotspot.
Zhongchu Tian, Binlin Xu
doaj +1 more source
Experimentally measurement and analysis of stress under foundation slab [PDF]
, 2017 Understanding of a load redistribution into subsoil below building foundation is an important knowledge for reliable design and its economy too. The article presents the results of a physical model of a foundation slab and its interaction with the ...
Lahuta, Hynek +4 more
core +1 more source
Shock and Vibration, 2023 In this paper, a rock dynamic and static triaxial mechanical test system is adopted to conduct triaxial compression failure acoustic emission test on coal rock with outburst-proneness.
Kun Zhang +5 more
doaj +1 more source