Results 111 to 120 of about 3,327,462 (275)
Investigating the Dynamic Creep of Polymer Modified Hot Mix Asphalt
Civil and Environmental EngineeringJordan's road network continues to deteriorate as a consequence of the continuous increase in traffic and the absence of adequate maintenance work. The primary objective of this study was to enhance HMA performance by using polymer-modified asphalt ...
Suleiman Ghassan +5 more
doaj +1 more source
, 2015 Resilient modulus is an important parameter to characterise the resilient behaviour of pavement materials. Resilient modulus can be determined in the laboratory from repeated load triaxial test and is defined as the ratio of deviator stress to ...
Bao Thach Nguyen (19970343) +1 more
core
On‐Skin Wireless Vibratory Interfaces by Stretchable Multilayer Circuits
Advanced Materials Interfaces, EarlyView.A battery‐free, stretchable wireless vibratory interface is developed through printable liquid‐metal‐based multilayer circuits. The soft device integrates wireless power reception, signal modulation, and vibrotactile actuation within a compliant platform.
Jiawei Liu +10 more
wiley +1 more source
Advanced Materials Technologies, EarlyView.Hierarchical multi‐material TPMS lattices are engineered as flexible tactile sensors by combining soft and stiff elastomeric layers with a conformal conductive coating. The bilayer architecture delivers sensitivity at low pressures while maintaining a broad detectable range under large loads, enabling reliable pressure and vibration monitoring for ...
Reza Noroozi +3 more
wiley +1 more source
Exploring the Potential of Waste Cooking Oil in Enhancing Warm Mix Asphalt Performance
Disaster in Civil Engineering and ArchitectureThe growing need for sustainable materials in road construction has led to the investigation of waste cooking oil (WCO) as a modifier for warm mix asphalt (WMA).
Ahmad Mujahid Hamzah +5 more
doaj +1 more source
Bio-Inspired Gradient Coatings Enhance the Leading Edge Erosion Resistance of Wind Blades. [PDF]
Adv Sci (Weinh)Rain‐induced erosion of the wind turbine blade leading edge poses a critical challenge to maintenance and operation. Here, we propose a bio‐inspired approach for erosion protection utilising a platelet‐reinforced polyurethane coating with a graded through‐thickness architecture.
Guevara-Sotelo NS, Teuwen J, Masania K.
europepmc +2 more sources
Dynamic and Resilient Modulus of Mn/DOT Asphalt Mixtures
, 2003 This report presents the results of laboratory testing to determine the complex modulus and phase angle of asphalt mixtures. Laboratory tests were performed on four different asphalt mixtures from the Mn/ROAD site.
Skok, Eugene L. +3 more
core
Evolution of OLED Lamination Technology With Development of Display Form Factors
Advanced Materials Technologies, EarlyView.This review evaluates the evolution of organic light‐emitting diode (OLED) lamination technologies alongside advancing display form factors. It contrasts optically clear adhesives and resins, highlighting uniformity control for rigid screens, bubble‐free optimization for bended architectures, and visible‐light curing for foldable layers.
Kwan‐Young Han, Ji‐Hoon Park
wiley +1 more source
Nature‐Derived Chitosan Biopolymer: A Promising Candidate for Sustainable Electronics
Advanced Materials Technologies, EarlyView.In the creation of environmentally friendly devices, nature‐derived chitosan biopolymer is a promising contender for sustainable electronic research. It can be utilized to create more ecologically friendly scalable gadgets and has a variety of uses in different active layers of electronics.
Joshua McDonald +3 more
wiley +1 more source
Complex Modulus Determination of Asphalt Concrete Using Indirect Tension Test
, 2004 The purpose of this research is to present the results from an analytical/experimental study on the dynamic modulus testing of hot mix asphalt (HMA) using the indirect tension (IDT) mode.
Momen, Mostafa
core