Results 91 to 100 of about 35,599 (288)
2017年8月9日精河MS6.6地震余震序列精定位及发震构造分析
为确定2017年8月9日精河MS6.6地震的发震构造,本文使用双差定位方法对发震时刻至2017年10月震源区所发生的余震进行了精定位,同时利用CAP波形反演方法,得到了主震的震源机制解,同时使用GPAT方法反演得到了部分余震的震源机制解,并基于两者对本次地震的发震构造予以分析。结果显示:精定位后主震位于(44.27°N,82.85°E),震源深度为17 km;主震最佳双力偶解对应的节面Ⅰ的走向为260°、倾角为51°、滑动角为84°,节面Ⅱ的走向为89.5°、倾角为39.4°、滑动角为97.4 ...
Liang Zhai, Xiaodong Zhang, Weijun Wang
doaj +1 more source
Fluid flow through a single fracture is commonly described by the cubic law. However, deviations from this model are expected because natural fracture surfaces are rough and in contact with each other in discrete regions. In this study, the interactions between fracture closure, contact area, and hydraulic characterization of mesoscopic‐scale rough ...
Chenghao Han +5 more
wiley +1 more source
The role of science in physical natural hazard assessment : report to the UK Government by the Natural Hazard Working Group [PDF]
Following the tragic Asian tsunami on 26 December 2004, the Prime Minister asked the Government’s Chief Scientific Adviser, Sir David King, to convene a group of experts (the Natural Hazard Working Group) to advise on the mechanisms that could and ...
Boulton, G. +14 more
core
How artificial intelligence (AI) and digital twin (DT) technologies are revolutionizing tunnel surveillance, offering proactive maintenance strategies and enhanced safety protocols. It explores AI's analytical power and DT's virtual replicas of infrastructure, emphasizing their role in optimizing maintenance and safety in tunnel management.
Mohammad Afrazi +4 more
wiley +1 more source
Study on fracture parameter calibration and failure characteristics of rock with hole and crack
The SIF and plastic zone equations for a single hole and crack have been derived. The model's failure state leads to the identification of four types of cracks. The plastic zone increases with increased brittleness and decreased crack length. Abstract Cracks within the surrounding rock of roadways significantly affect their stability and failure ...
Shaochi Peng, Wensong Wang
wiley +1 more source
Review and prospects of shear test of bolted rock joints
The laboratory shear test equipment, test method, and numerical simulation of bolted rock joints were summarized. The shortcomings and limitations of the current research were analyzed, and the research prospects were proposed. Abstract Rock bolting is a critical approach in geotechnical engineering for supporting weak rocks.
Shulin Ren +4 more
wiley +1 more source
Progress in mantle anisotropy research based on XKS phases
XKS shear-wave splitting has been widely applied to investigations of anisotropy in both the upper mantle and the lowermost mantle D" layer, and represents a key tool for probing mantle deformation and dynamics.
Junshu Wang +4 more
doaj +1 more source
Machine learning and earthquake forecasting-next steps. [PDF]
Beroza GC, Segou M, Mostafa Mousavi S.
europepmc +1 more source
Temperature‐dependent shear behavior and constitutive model of the rock–concrete interface
Shear tests were conducted to investigate the temperature‐dependent shear behavior of the rock–concrete interface, highlighting the interaction between the surrounding rock and the lining during tunnel fires. Under experimental conditions, concrete exhibited greater temperature sensitivity than rock, with the shear fracture surface transitioning from ...
Hongbin Chen +6 more
wiley +1 more source
Laboratory earthquake forecasting: A machine learning competition. [PDF]
Johnson PA +13 more
europepmc +1 more source

