Results 121 to 130 of about 41,583 (295)
A multifunctional benzimidazole‐terminated CNF separator is constructed via a PEI‐mediated covalent locking strategy, generating dense zincophilic sites that accelerate Zn2+ transport and desolvation while enabling uniform Zn (002) deposition and suppressing side reactions.
Jie Liang +17 more
wiley +1 more source
Electric‐Current‐Induced Phase Transformation in Cu6Sn5 Below Its Equilibrium Transition Temperature
Electric current induces a monoclinic‐to‐hexagonal phase transformation in Cu6Sn5 at a measured bulk temperature of ∼120°C, below the equilibrium transition temperature. Ex situ synchrotron x‐ray diffraction, TEM, and matched thermal controls show that current stressing promotes the formation of a retained hexagonal η‐phase post‐stress state not ...
Shih‐kang Lin +3 more
wiley +1 more source
Abstract Background Electron backscattered diffraction (EBSD) is a very powerful analysis technique to understand the crystallography of a sample in the SEM. Typically, a high beam current is needed to obtain good results because of inefficient collection of the patterns.
openaire +1 more source
Intrinsic Mechanical Parameters and their Characterization in Solid‐State Lithium Batteries
This review focuses on the intrinsic mechanical parameters and their associated characterization in solid‐state batteries. The physical significance of mechanics parameters is introduced with exhaustive classifications by elastic, plastic deformations and fracture in bulk, adhesion, friction at interfaces, and mechanical fatigue in cells ...
Shuai Hao +5 more
wiley +1 more source
Reidite Formation From Zircon Subjected to 20, 40, and 60 GPa Shock Experiments
Structure disordering as a result of shock pressure: In zircon shocked from 20 to 60 GPa, the shock‐induced structural disorder increases with increasing shock pressure (gray area). Shock disorder of zircon is an integral part of its transformation to reidite: Reidite occurs after amorphous material.
Dmitry A. Zamyatin, Elizaveta Kovaleva
wiley +1 more source
S32750 duplex stainless steel samples with different initial microstructures obtained by solid solution heat treatment (SHT) were cold rolled with the thickness reduction of 80% and subsequently annealed at 1050℃.
LI Hao-qing +4 more
doaj
A 1 μm active‐split design enables poly‐IGO TFTs with high electrical performance, low hysteresis, excellent bias stability, and robust mechanical reliability on a flexible PI substrate. ABSTRACT We report high‐performance, polycrystalline indium–gallium–oxide (poly‐IGO) thin‐film transistors (TFTs) based on an active split structure with 1 μm unit ...
Seongcheol Moon, Heonbang Lee, Jin Jang
wiley +1 more source
Optimizing the EBSD Signal [PDF]
A Deal, A Eades
openaire +1 more source
This work elucidates the previously unknown thermal dynamics during sub‐micrometer photothermal laser printing of zinc oxide using a non‐invasive transmission‐based in situ measurement. The elevated temperatures are shown to be highly localized around the laser focal spot, reaching average temperature increases of about 113 K per mW of laser power ...
Steven Kraus +4 more
wiley +1 more source
By refining grains and additions of strengthening elements, mechanical properties of electro‐conductive copper can be increased. Fine‐grained coper‐graphene composites were directly consolidated from original powders by rotary swaging to achieve rods with enhanced mechanical properties and electric conductivity of up to 96% international annealed ...
L. Kunčická +4 more
wiley +1 more source

