Results 91 to 100 of about 2,713,761 (316)
Advanced Engineering Materials, EarlyView.The tribological behavior of 100Cr6 steel spheres textured via Vickers microindentation is evaluated under lubricated sliding by varying both dimple size and density. Fine and dense textures significantly reduce friction across all lubrication regimes, while large dimples increase it.
Farideh Davoodi +3 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Economic forecasting: state agency needs evaluation [1979]
, 1979 This document is produced as a part of the Kansas Statewide Development Planning Program supported by a 302(a)--grant from the Economic Development Administration, U.S. Department of Commerce.
Kansas Department of Economic Development, Planning and Community Development Division
core
IDB America: Vol. 26, no. 11-12, November-December 1999
, 1999 IDB America reports on economic and social development trends in Latin America and the Caribbean and on the activities of the IDB.
Inter-American Development Bank
core +1 more source
Improving Infrastructure Financing in Brazil [PDF]
, 2019 This report presents a series of recommendations intended to address some of the main challenges facing Brazil\u27s infrastructure sector as it transitions to a new financing model in which the National Bank for Economic and Social Development (BNDES ...
Inter-American Development Bank
core +1 more source
Advanced Engineering Materials, EarlyView.This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira +4 more
wiley +1 more source
Insights into PCI and DDCI as Key Metrics for Measuring Subnational Competitiveness in Vietnam
Institutiones AdministrationisThe purpose of this study is to review and understand Vietnam’s measurement of competitiveness for its local authorities. This paper delves into the application of two fundamental metrics, namely the Provincial Competitiveness Index (PCI) and the ...
Phuong-Duy Nguyen +2 more
doaj +1 more source
Economic development strategy. Updated 2018: May.
, 2018 Updated May, 2018.; At head of title: Connecticut, still revolutionary.; Previously issued: 2015 economic development strategy.; Includes bibliographical ...
Connecticut. Department of Economic and Community Development,
core
IDB America: Vol. 25, no. 1-2, January-February 1998
, 1998 IDB America reports on economic and social development trends in Latin America and the Caribbean and on the activities of the IDB.
Inter-American Development Bank
core +1 more source
Advanced Engineering Materials, EarlyView.This study presents an infrared monitoring approach for direct laser interference patterning (DLIP) combined with a convolutional neural network (CNN). Thermal emission data captured during structuring are used to predict surface topography parameters.
Lukas Olawsky +5 more
wiley +1 more source