Results 111 to 120 of about 19,779,279 (309)
Community economic development assessment: Edna, Kansas
, 1989 Community development assessment team members: George Mathews, Carlene Hurtig and Ken Sherraden. "February, 1989."Introduction -- Executive Summary -- Chapter I - Travel and Tourism -- Training And Cooperation in Tourism -- Promoting Special Attractions -
Kansas Department of Commerce, Community Development Division
core
Architecture‐Driven Sensor Stability in Weft‐Knitted Engineering Textiles
Advanced Engineering Materials, EarlyView.Textile‐integrated sensor architectures are systematically compared to evaluate their electromechanical behavior under combined mechanical and environmental loading. Pocket‐based integration exhibits stable and reproducible signals, whereas tunnel‐based routing shows higher sensitivity accompanied by increased variability.
Adnan Maroof Khan +5 more
wiley +1 more source
Community economic development assessment: Goddard, Kansas
, 1990 "June, 1990."INTRODUCTION -- CHAPTER I - INDUSTRIAL DEVELOPMENT -- Prospecting for New Industry -- Working with Existing Industry -- Strategic Planning -- Recommendations for Industrial Development -- CHAPTER II - COMMERCIAL AREAS -- Maintenance and ...
Kansas Department of Commerce, Community Development Division
core
IDB America: Vol. 24, no. 12, December 1997
, 1997 IDB America reports on economic and social development trends in Latin America and the Caribbean and on the activities of the IDB.
Inter-American Development Bank
core +1 more source
Advanced Engineering Materials, EarlyView.Sustainability assessment requires methodologies that appropriately distinguish between additive and non‐additive material properties. A toxicity‐weighted scoring system is developed and applied that accounts for the disproportionate influence of highly toxic constituents through nonlinear weighting functions, providing more realistic estimates than ...
Seth Mehalic +2 more
wiley +1 more source
The IDB: Vol. 22, no. 11, November 1995
, 1995 The IDB reports on economic and social development trends in Latin America and the Caribbean and on the activities of the Bank.
Inter-American Development Bank
core +1 more source
Advanced Engineering Materials, EarlyView.CT‐based finite element simulations combined with in situ X‐ray computed tomography are used to analyze insert pull‐out in nickel‐coated polymer foams. Despite variations in material parameters, deformation consistently concentrates within a narrow annular region around the insert.
Yannik Bautz +4 more
wiley +1 more source
Economic forecasting: state agency needs evaluation [1979]
, 1979 This document is produced as a part of the Kansas Statewide Development Planning Program supported by a 302(a)--grant from the Economic Development Administration, U.S. Department of Commerce.
Kansas Department of Economic Development, Planning and Community Development Division
core
The IDB: Vol. 24, no. 11, November 1997
, 1997 The IDB reports on economic and social development trends in Latin America and the Caribbean and on the activities of the Bank.
Inter-American Development Bank
core +1 more source
A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation
Advanced Engineering Materials, EarlyView.A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler +4 more
wiley +1 more source