Results 51 to 60 of about 100,653 (265)

Hydrogen‐Assisted Fracture of Iron‐Based Fe–Ni–Al Alloys

open access: yesAdvanced Engineering Materials, EarlyView.
Principal relations and fracture mechanisms of single‐phase and precipitate‐strengthened Fe–Ni–Al alloys subjected to prior electrochemical hydrogen charging are identified. The mechanisms of hydrogen effect on strength and microhardness are discussed, including hydrogen‐induced increase in microhardness and the role of hydrogen in fracture behavior ...
Nataliya Yadzhak   +3 more
wiley   +1 more source

Fatigue Crack Initiation and Growth in Nanocrystalline Ni at Multiple Length‐Scales

open access: yesAdvanced Engineering Materials, EarlyView.
Overview of miniaturized in situ SEM fatigue setup and resultant fatigue crack growth data for nanocrystalline Ni. The presented study focuses on the analysis of fatigue crack growth rate (FCGR) in focused ion beam‐notched microcantilevers prepared from nanocrystalline (NC) Ni as a model material.
Igor Moravcik   +7 more
wiley   +1 more source

Effect of Axial Deformation on Elastic Properties of Irregular Honeycomb Structure

open access: yesChinese Journal of Mechanical Engineering, 2021
Irregular honeycomb structures occur abundantly in nature and in man-made products, and are an active area of research. In this paper, according to the optimization of regular honeycomb structures, two types of irregular honeycomb structures with both ...
Ning Wang, Qingtian Deng
doaj   +1 more source

Creep‐Induced Microstructural Evolution in an A2‐B2 Superalloy

open access: yesAdvanced Engineering Materials, EarlyView.
A 27.3Ta‐27.3Mo‐27.3Ti‐8Cr‐10Al (at.%) refractory high‐entropy alloy with precipitation‐strengthened A2‐B2 microstructure was studied by creep tests at 1030°C, which demonstrate a transition in deformation mechanisms in the range of 100–150 MPa applied stress. This is associated with changes in dislocation–precipitate interactions. Relevant deformation
Liu Yang   +10 more
wiley   +1 more source

Nonlinear Elastic Deformation of Mindlin Torus

open access: yesCommunications in Nonlinear Science and Numerical Simulation, 2021
The nonlinear deformation and stress analysis of a circular torus is a difficult undertaking due to its complicated topology and the variation of the Gauss curvature. A nonlinear deformation (only one term in strain is omitted) of Mindlin torus was formulated in terms of the generalized displacement, and a general Maple code was written for numerical ...
openaire   +2 more sources

Influence of Test Temperature and Test Frequency on Fatigue Life of Aluminum Alloy EN AW‐2618A

open access: yesAdvanced Engineering Materials, EarlyView.
The influence of test temperature and test frequency on the fatigue life of EN AW‐2618A is investigated. High‐cycle fatigue tests are performed at different test temperatures and frequencies on the 1000 h/230°C overaged state. Both test parameters reduce fatigue life due to time‐dependent damage mechanisms.
Ying Han   +5 more
wiley   +1 more source

Elasticity, Viscosity, and Deformation of Orbital Fat

open access: yesInvestigative Opthalmology & Visual Science, 2006
For development of a finite element analysis model of orbital mechanics, it was necessary to determine the material properties of orbital fat and its degree of deformation in eye rotation.Elasticity and viscosity of orbital fat of eight orbits of four calves and two orbits of one rhesus monkey were measured with a parallel-plate rheometer.
Schoemaker, I   +10 more
openaire   +3 more sources

Experimental study on elastic deformation properties of geomembranes used as barriers in upper reservoir of pumped storage power stations

open access: yesYantu gongcheng xuebao
Aimming at the deformation adaptability of geomembranes used as barriers in the upper reservoir of pumped storage power stations, a set of bubble inflation multiaxial tension testing equipment for geomembranes is developed.
ZHAO Hongyu, WU Haimin , SHU Yiming, YI Feng
doaj   +1 more source

High‐Temperature Nanoindentation of Metals: Assessing Thermal Drift, Frame Compliance, and Chemical Composition Effects on the Reported Mechanical Properties

open access: yesAdvanced Engineering Materials, EarlyView.
Do not let thermal drift and instrument artifacts deceive high‐temperature nanoindentation results. We compare classical Oliver–Pharr and automatic image recognition analyses across steels and a Ni alloy to quantify these effects. Accounting for artifacts reveals systematic softening with temperature, while Cr and Ni additions boost resistance ...
Velislava Yonkova   +2 more
wiley   +1 more source

Elastic Matching Using a Deformation Sphere [PDF]

open access: yes, 2001
A novel method is proposed for elastic matching of two data volumes. A combination of mutual information, gradient information and smoothness of transformation is used to guide the deformation of another of the volumes. The deformation is accomplished in a multiresolution process by spheres containing a vector field.
Jyrki Lötjönen, Timo Mäkelä
openaire   +2 more sources

Home - About - Disclaimer - Privacy