Results 61 to 70 of about 91,902 (263)

Review of Electric-Carbon Coupling Market Studies： Status，Challenges，and Sustainability Perspectives [PDF]

Dianli jianshe
In response to global climate change and the urgent need for energy sustainability，governments worldwide have proposed strategic frameworks for carbon emissions reduction and renewable energy development.
ZHU Jizhong, XIE Chuchu, ZHANG Di, LAN Jing, ZHOU Jialin
doaj   +1 more source

Innovative Processing of Compacted Waste Aluminum Alloy Powders via Controlled Remelting and Solidification

Advanced Engineering Materials, EarlyView.
This study demonstrates an efficient recycling route for out‐of‐spec AlSi10Mg atomized powders through compaction and arc remelting followed by suction casting. By correlating compaction load, cooling rate, and resulting microstructure, we show that intermediate pressures (50–80 kN) and rapid cooling refine dendrites, reduce porosity, and enhance ...
Mila Christy de Oliveira, Marcella Gaute Cavalcante Xavier, Abdoul‐Aziz Bogno, Piter Gargarella, José Eduardo Spinelli   +4 more
wiley   +1 more source

Strain gradient and electric field gradient effects in piezoelectric cantilever beams

Journal of the Mechanical Behavior of Materials, 2015
A piezoelectric beam model with strain gradient and electric gradient effects is proposed. An energy variational principle with strain, strain gradient, electric field, and electric field gradient considered as independent variables is postulated to ...
Yue Yanmei, Xu Kaiyu, Aifantis Elias C.
doaj   +1 more source

Influence of Rotor-Bearing Coupling Vibration on Dynamic Behavior of Electric Vehicle Driven by In-Wheel Motor

IEEE Access, 2019
In order to analyze the influence of the rotor-bearing coupling vibration on the dynamic performance of electric vehicles driven by an in-wheel motor, taking a typical four-phase 8/6-pole switched reluctance motor driven electric vehicle without ...
Yuewei Yu, Leilei Zhao, Changcheng Zhou
doaj   +1 more source

Variable Stiffness Flexure Structures Enabled by Phase‐Change Gallium and Adhesive Interfacial Locking for Soft Robotic Applications

Advanced Engineering Materials, EarlyView.
A flexure‐based variable stiffness structure is developed by integrating phase‐change modulation and adhesive interfacial locking of gallium. The design enables a wide stiffness variability, transitioning from soft, flexible behavior to rigid, load‐supporting performance.
Sungjin Kim, Sohee John Yoon, Yong‐Lae Park   +2 more
wiley   +1 more source

Light-wave control of correlated materials using quantum magnetism during time-periodic modulation of coherent transport

Communications Physics, 2021
With no direct coupling between spin and light, transient magnetic switching typically proceeds on longer timescales and requires indirect coupling via electric fields.
Panagiotis C. Lingos, Myron D. Kapetanakis, Jigang Wang, Ilias E. Perakis   +3 more
doaj   +1 more source

Composition‐Tuned Enhancement of the Anomalous Nernst Effect in FeCo–Pt Thin Films on Rigid and Flexible Substrates

Advanced Engineering Materials, EarlyView.
Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi, Hiroyuki Awano, Kenji Tanabe   +2 more
wiley   +1 more source

Low‐Angle Grain Boundaries and Re‐Segregation in Single‐Crystalline Ni‐Base Superalloys

Advanced Engineering Materials, EarlyView.
This work demonstrates that Re‐segregation at low‐angle grain boundaries (LAGBs) in Ni‐base superalloys is influenced by misorientation angle. Advanced microscopy and atom probe tomography reveal that higher misorientation angles increases Re‐segregation.
Alireza B. Parsa, Aparna Saksena, Alesander Kostka, Pascal Thome, Felicitas Scholz, Alexandre Mussi, Christoph Somsen, Baptiste Gault, Jan Frenzel, Gunther Eggeler   +9 more
wiley   +1 more source

Modelling electric field control in a 4f molecular qudit with hyperfine coupling

Communications Chemistry
Understanding the fundamental principles of spin-electric coupling in molecules with hyperfine-coupled electronic and nuclear spins offers a route to electric field-based molecular quantum information.
William T. Morrillo, Andrea Mattioni, William J. A. Blackmore, David P. Mills, Nicholas F. Chilton   +4 more
doaj   +1 more source

Additive Manufacturing of Continuous Fibre Reinforced Composites: Process, Characterisation, Modelling, and Sustainability

Advanced Engineering Materials, EarlyView.
Additive manufacturing provides precise control over the placement of continuous fibres within polymer matrices, enabling customised mechanical performance in composite components. This article explores processing strategies, mechanical testing, and modelling approaches for additive manufactured continuous fibre‐reinforced composites.
Cherian Thomas, Amir Hosein Sakhaei
wiley   +1 more source