Results 121 to 130 of about 2,207,218 (336)
Assessment of Postnatal Pulmonary Adaption in Bovine Neonates Using Electric Impedance Tomography (EIT). [PDF]
Animals (Basel), 2021 Bleul U +4 more
europepmc +1 more source
Advanced Engineering Materials, EarlyView.This article presents the design, modeling, and characterization of air‐pressure–actuated programmable vibroacoustic metamaterials (PVAMM). The study focuses on leveraging air pressure to dynamically tune resonance frequencies for effective noise attenuation.
William Kaal +2 more
wiley +1 more source
Revista Colombiana de Obstetricia y Ginecología, 2010 Objetivo: obtener las curvas de resistividad eléctrica de tejido cervical en presencia de cáncer invasivo del cuello uterino. Metodología: estudio de corte transversal en pacientes con carcinoma invasor del cérvix.
Germán Olarte-Echeverri +3 more
doaj
Advanced Engineering Materials, EarlyView.Disordered (Fe50Co50)1−xPtx thin films exhibit a pronounced anomalous Nernst effect (ANE) with a strong composition dependence on both rigid and flexible substrates. The transverse thermoelectric response peaks near 22.5 at.% Pt, accompanied by enhanced αxy/σxy scaling, thermal transport, and ANE sensitivity.
Mojtaba Mohammadi +2 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Four‐point bending tests are conducted in an argon atmosphere on commercial MgO‐C brick grades with and without MgO‐C recyclate from room temperature up to 1300 °C. No detrimental effect of the MgO‐C recyclates on bending strength is found. Instead, a decisive influence of the total carbon content is observed, with lower total carbon contents ...
Alexander Schramm +5 more
wiley +1 more source
World Electric Vehicle JournalAccurate prediction and efficient suppression of conducted electromagnetic interference(EMI) in electric drive systems(EDS) are achieved through an innovative technique proposed in this paper, leveraging a key path impedance characteristic model.
Ruoxi Tan +4 more
doaj +1 more source
The design of an electric fence monitoring system : a thesis presented in partial fulfilment of the requirements for the degree of Master of Technology in Production Technology at Massey University [PDF]
, 1996 This thesis presents the design of an Electric Fence Monitoring System (EFMS) which detects and announciates fence malfunctions indicating operational ineffectiveness. The EFMS consists of a master unit and up to sixteen slave units.
Adamson, Paul Robert
core
Advanced Engineering Materials, EarlyView.This study investigates thermo‐chemical processes during high‐temperature testing of two commercial MgO‐C brick grades, one containing 47.5 wt.% MgO‐C recyclate. Using ETV, DTA/TG‐MS, XRD, and SEM/EDS/EBSD, mechanisms such as carbothermal reduction of magnesia, impurity incorporation into the secondary MgO surface layer, and calcium‐rich phase ...
Alexander Schramm +6 more
wiley +1 more source
IET Electric Power ApplicationsDue to the increasing variety of converters in more electric aircraft (MEA), the stability of the MEA power system has become a critical issue that receives wide concerns.
Zixiao Xu +5 more
doaj +1 more source
Thermophysical Properties of the Desulphurization Slags With Various CaS and CaO/Al2O3 Ratio
Advanced Engineering Materials, EarlyView.This article investigates how CaS content and the CaO/Al2O3 ratio influence the thermophysical properties of desulphurization slags. Using experimental measurements and thermodynamic simulations, this study reveals complex effects on viscosity, surface tension, and density, providing new insight into slag structure and phase behavior under ...
Eldar Salpagarov +4 more
wiley +1 more source