Results 51 to 60 of about 131,396 (199)
Load flow, short circuit and motor starting studies in electrical power substations.
Power system studies are essential for the proper planning and design of electrical power substations. This paper presents the load flow, short circuit, and motor starting studies for 33/6.6/0.44 kV electrical power substation.
Mohan Muniappan
doaj +1 more source
ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo +10 more
wiley +1 more source
Graphene-Enhanced CuW Composites for High-Voltage Circuit Breaker Electrical Contacts
To address the issue of over-standard short-circuit currents in a power system, it is imperative to enhance the comprehensive performance of the electrical contacts, which serve as the lynchpin of circuit breakers, so as to improve the breaking capacity ...
Tan Liu +6 more
doaj +1 more source
A soft, dual‐channel hydrogel patch enables simultaneous detection of wound temperature and strain by integrating ion‐diffusion‐mediated thermoelectric and resistive sensing. The conformal design maintains stable performance during motion, capturing subtle inflammatory and mechanical changes for continuous wound monitoring.
Yu Fang +7 more
wiley +1 more source
Here, we provide the reader with the current state of the art in the fabrication of high‐T2‐coherence diamond, optimized through the use of double electron–electron resonance (DEER) spectroscopy. We reveal the main as well as yet unidentified spin defects, the reduction of which is essential for reducing the spin bath and fabricating materials for ...
Olga Rubinas +6 more
wiley +1 more source
Fully additive vertical organic electrochemical transistors (vOECTs) with channel‐length of 226 nm on a 50 µm compostable substrate achieve >106 current modulation and ∼36 mS transconductance. Ion‐selective integration enables 1.1 mA dec−1 sensitivity and 36 µm detection limit, highlighting a scalable platform for sustainable electronics and ...
Giulia Frusconi +3 more
wiley +1 more source
We present electrical and optical $(\lambda =\rm {850~nm })$ measurement results of back-gate controlled SOI PIN-diodes without a front-gate, with an intrinsic Si film thickness of only ${\sim }\rm 6nm $ .
Jelle H. T. Bakker +4 more
doaj +1 more source
Energy Recovery for the Main and Auxiliary Sources of Electric Vehicles
Based on the traditional regenerative braking electrical circuit, a novel energy recovery system for the main and auxiliary sources of electric vehicles (EVs) has been developed to improve their energy efficiency.
Binggang Cao, Shengjie Jiao, Min Ye
doaj +1 more source
Omnipolar Magnetic Field Detection by Superlattice‐Based Hall Sensor
Magnetic‐field‐induced electronic switching is demonstrated in unit‐cell‐engineered La0.7Sr0.3MnO3–BiFeO3 superlattices. Distinct substrate terminations modify magnetic and transport properties. Hall resistance measurements show omnipolar, hysteretic anomalous Hall switching above the Curie temperature, arising from Fe─Mn interfacial exchange, enabling
Mark Huijben +6 more
wiley +1 more source
Spatially Modulated Morphotropic Phase Boundaries in a Compressively Strained Multiferroic Thin Film
ABSTRACT The coexisting rhombohedral‐like (R′, MA) and tetragonal‐like (T′, MC) monoclinic phases in compressively strained bismuth ferrite thin films exhibit exceptional piezoelectric and magnetic properties. While previous studies have largely focused on probing the morphotropic phase boundaries (MPBs) comprising ordered R′/T′ twins, their self ...
Ting‐Ran Liu +7 more
wiley +1 more source

