Results 61 to 70 of about 87,647 (307)
Advanced Engineering Materials, EarlyView.This study examines how several molten high‐silicon electrical steels interact with both conventional and recycled MgO–C refractories. For this, various immersion experiments are conducted. In addition to infiltration, a number of mechanisms are identified and explained that control the corrosion of the refractory material.
Lukas Neubert +7 more
wiley +1 more source
Tekhnologiya i Konstruirovanie v Elektronnoi Apparature, 2016 In this article, we consider the method of constructive parameters' calculation of the elastic elements, which are used in electrical connectors of flexible printed cables.
A. A. Yefimenko, S. V. Merlyan
doaj +1 more source
Pressure transducer with four-decade dynamic range [PDF]
, 1971 Adjustable resistor taps in gain-control feedback loop of the transducer permit wide sensing range, shorting the pins on electrical connector allows selection of appropriate range.
core +1 more source
Advanced Engineering Materials, EarlyView.It is shown that laser ablation pretreatment under oxygen‐free conditions enables copper–aluminium bonding at significantly lower deformation degrees and improved properties compared to mechanical brushing. Laser ablation further increases interface contact area and induces favourable residual stress states and microstructural compatibility ...
Khemais Barienti +11 more
wiley +1 more source
A novel technique and soldering method to improve performance of transparent polymer antennas [PDF]
, 2010 This article is archived here with permission from IEEE - Copyright @ 2010 IEEEA novel technique and a non-thermal soldering method to improve the performance of AgHT-8 transparent polymer antennas are proposed in this paper.
AbuTarboush, HF +3 more
core +1 more source
Advanced Engineering Materials, EarlyView.Carbon nanomaterial‐reinforced epoxy composites exhibit pronounced piezoresistive behavior, enabling intrinsic damage sensing under cyclic and fatigue loading. This review critically compares carbon nanotube and graphene systems, correlating filler content, percolation threshold, and gauge factor with sensing stability and damage evolution.
J. M. Parente +3 more
wiley +1 more source
EMUs Electrical Connector Life Prediction Based on Accelerated Degradation Data
机车电传动, 2019 The electrical connectors of EMUs play a very important role in train operation. In order to improve the efficiency and accuracy of life prediction of electrial connector products, the connector accelerated test was designed and implemented, and the ...
Jie MA +4 more
doaj
Electrical grounding bracket [PDF]
, 1972 Device serves as common grounding point for shielded wires of multipin electrical connector and permits addition or removal of ground leads without disturbing other grounded ...
Carroll, C. E.
core +1 more source
3D‐Printed Giant Magnetoresistive (GMR) Sensors Based on Self Compliant Springs
Advanced Engineering Materials, EarlyView.This work explores 3D‐printed GMR sensors utilizing self‐compliant spring structures and conductive PLA composites. By optimizing arm width, we achieved high piezoresistive (0.34%/mm) and magnetoresistive (0.77%/mT) sensitivities. Demonstrated through Bluetooth‐integrated pressure and magnetic position sensing, these full printed low‐cost, customizable
Josu Fernández Maestu +4 more
wiley +1 more source
Underwater Wet Electrical Connector Seal Life Prediction
Shiyou jixie, 2017 Underwater wet electrical connector is a connecting device used to connect underwater equipment in the working environment of sea water, oil and drilling fluid. Due to its harsh working environment, its sealing technology is of great importance.
Hu Dong +4 more
doaj